开云体育

If he were instead to sell it, He may find the market really too small to be worthwhile. Probably no profit motive here otherwise.

If you are so inclined, I think it would be great for you to release the design, perhaps in the files section here. I have an original HP Logic Clip, but I would like to construct a few of your

Well - as I wrote I didn't put pads on my layout for the 2 interconnections, but I did mount 2 wire between the boards Any of the 16 pins can provide power and ground The reason for not putting on

As one who repaired a few logic clips back in the day it looks like the DIY approach above missed something HP did, which was to interconnect the Vcc and local ground busses across both sides of the

I made me own Logic Clip (I really wanted a HP one, but they are very expensive now) Just made 2 (equal) boards with 8 x dual diodes, for tapping off power and ground 8 x LED and a resistor (rect. 3 x

Some groups features are a bit baffling Hopefully the scanned content is of use to people Peter

Mea culpa.. :-) Barry - N4BUQ

Mark- your post reminded me of the 970A and accessories I have here- with the same issue-I need to rebuild something to replace the battery pack-I do have the dimensions that someone on here sent me a

I had the same reaction. Eventually I came across some information about it. It appears there are a couple (probably more now) of devices to do the conversion and some fairly common pcbs to support

Dave and Mark: Just let me know if and when. Raymond

Sure, let me know if you need it. Gary

Hi, Gary, Yes, that's the meter.? I'm actually only interested in the battery pack, and I may already have a line on one; if that doesn't work out, perhaps I could borrow yours for a bit to measure

Oh. Right. Good point. I apologjze. It's just that there seems to have been a trend over the past few years where people DO post with uneccessarily loooonnngg subject lines. I guess I am just

PS, there is a ground wire that broke off when I removed it from the case, looks like the rubber deteriorated. Gary Sent: Monday, November 4, 2024 6:29 PM To: [email protected]

Like this? Not sure if pictures come through this list. Gary WA2OMY Sent: Monday, November 4, 2024 6:29 PM To: [email protected] Subject: [HP-Agilent-Keysight-equipment] New to

It's great to see you on this list too, Mark, Welcome! I'm a decade behind you at 55, but I'm in essentially the same situation, minus (unfortunately) the music and audio stuff.

Hi, I did the same tests as you, results in the tables. I attached a picture showing the diodes of the first mixer, I did the repair of two Spectrum this year with damaged diodes, so the one with

Hello! I've used HP test gear all of my life (I'm 65), and now have a pretty well-equipped electronics lab at home with probably half HP and half everything else.? I also have some older HP computer

Hello!? A while back, I picked up a box full of HP 970A probe multimeters - the ones that had a little 3-digit display right near the tip.? There are about eight of them, in various stages of

For 12.4GHz option : For 3GHz option, see PDF file Yves De : [email protected] <[email protected]> De la part de victor smith Envoyé : 4 novembre 2024