开云体育

auto zero function explained on page 15 of the 8481A service manual.

Have pdf of op/service for the 4935A if that’s any use. Dave, ZL3FJ Sent: Thursday, March 20, 2025 11:55 To: [email protected] Subject: [HP-Agilent-Keysight-equipment]

Hello, Any one have a service manual for a HP 4934A? An electronic copy? Any good ideas where to find either a paper or electronic copy? It is for a TIMS. Transmission impairment measuring set. thank

Unless you plan to operate on 400 Hz AC current, you don’t need a 400 Hz fan. Depending on the instrument, you may be able to get by with a lower-power (quieter fan). HP typically spec’d their

Peter - yes - beast (trivia - back in about 1981 I was one of hundreds of volunteer extras (person-sized bird characters) for a movie being filmed north of Los Angeles called "the beastmaster" - never

Have a failing/failed cooling fan from a HP machine with OPT 003 (400 Hz), which appears to apply to the type of fan installed. Are there any requirements (trying remember undergraduate EE class that

UNOFFICIAL I have never encountered 3.5 mm in anything, and yes I have seen them on Amazon and AliExpress, but never at hardware shops, electronics parts suppliers ( similar to radio shack) or even

In my own shop, I am, kicking and screaming, "inching" towards the metric system.? I have a rather complete and well-organized set of little drawers for my SAE hardware, but the metric stuff

Hi, bought a E5071C 4-port 8.5GHz VNA. Seller stated that the device does not power up. Arriving home I connected it to power switched it on - it turns on, Fans blowing for 3-4 seconds, no other

HP series 200/300 and Plotter Manuals PM direct for offer… 7470A Plotter, Statistics, Graphic Presentation, Project Management, Basic 4.0… Interface Techniques, Utilities, Waveform Analysis,

The following items have been added to the Files area of the [email protected] group. * /All HP, Agilent and Keysight instruments in folders by part numbers/3000 to 3999/33xx

I also designed a 10 MHz LC resonator version with the aim to run the resonator at fairly high power. I've a fair bit of experience designing discrete low noise gain blocks so I replaced the noisy

Alberto, So, do you know if the CLIP document you have is useful for the E4422B or at least for the E4400-90141 module? If so, could you contact this email *santi.zygadlo@...* to reach an

I did of course Andrew, you are right. I was not well awake decidedly this morning!

(32 threads / inch) * (1 in / 25.4mm) = 1.2598 threads / mm 1/1.2598 = 0.79375 mm / thread (pitch) That's not even CLOSE to 0.6mm pitch (42 / 25.4) = 1.65354 threads / mm 1/1.65354 = 0.6048 pitch I

Sorry I got myself confused between the two systems! It's of course 5 micrometers so one large hair thickness! I kick myself...

Indeed in metric land 3.5x0.6 exists. If one calculates the diameter and pitch in mm of your 6-32 one gets: 3.505x0.605 which is just one micrometer too much or one fifth of your hair thickness... In

Radu Bogdan Dicher <vondicher@...> added the photo album Microscope ( /g/HP-Agilent-Keysight-equipment/album?id=301362 )

To assist with feedback on this local offer for the Nikon microscopes, I uploaded to the photos section pictures of the two units this local seller has:

What a beast. I’ll have to find one as a project. Peter