开云体育

Response to commands is usually postponed until the end of the current sweep. If the synth is having trouble locking, or the sweep is slow due to narrowband, or perhaps crossing band edges, command

I've seen a few open circuit failures of the 1500uF 15V capacitor in at least 2 of the counters from this series and some HP analog multimeters, other than that the others have been OK, a few of the

Guys, The 4 units of the BE19400013B have been sold. I have started building 4 more and when they are built and tested I will relist it on Ebay. Mike Bafaro From:

You can use the old vintage cans and put a newer, low ESR capacitors inside to keep the vintage look. Just make a simple pcb to solder the new cap inside and keep the old pins outside. Jurek

OK Scott, it has never been recapped as far as I know. I’ll look into how/where the supply voltages are tested and will probably just go ahead and recap to avoid any future supply

Hi Pete, Thanks for the reply. The neon bulb is working on the start and stop test function. When placed on the start position, the bulb comes on but the counter doesn’t display any counting. All

I just resurrected one. If the power supply hasn't been re-capped, check the supply voltages first.? In my case every d*** capacitor was bad.? Check back then.

Just an idea: In the case of the gate indicator (a neon bulb): try shining a bright light on it to see if that "fixes" it. As for "not counting", I don't know an alternative other than to probe

There are days when Murphy's Law just seems to run in overdrive mode, but the fun will resume in a few day and I hope to have more news soon ! Joel

Well, It did not go well lol. This is actually not that badly packed. It is somewhat dense but this is really well designed. The boards can be freed from their metal case easily, and A22 (AD board) is

I have several of the HP 5245L counters and until recently, had at least one working. Now it seems that the last “working” counter I own has gone belly up. Two of them have the same problem, (the

Thank you for that detail! Jeremy [email protected]> wrote:

Indeed, but with a 1000:1 probe that becomes a +/- 2000 volt input range which is sufficient. That was a work requirement and their solution covers more, although this would be sufficient for them

Peter, didn’t you have some high-voltage requirements for your application? Looks like the 54003A is limited to +/- 2 Volts, after whatever reduction the probe provides. (Just curious. I missed the

Thank to those who provided information I was able to successfully use 54003A input modules as 1 meg probe converter/extenders. For my company the current COTS device was used to allow remotely using

Not quite.? A USB solution was addressed earlier which is the defacto standard nowadays for communicating with old floppy deives under a modern OS.

Thanks, guys. Yes, what I really need to do above all is avoid over-torquing/over-stressing the connector at the point where it goes into the bulkhead. If I can get them apart without doing that, I

Hi Ozan. Thank you for that tip. Unfortunately the jack tests open. But the resistance on the jack contacts on the board reads 6.02 Mohm. So the fault is somewhere on the board. I have found other

Which Minolta do you have? I am in the process of trying to get a 2400DSV-E to talk to a PC myself

Can you determine which end has the threads out - the N adapter or the port? Then using a padded jaw pliers and the hex wrench, turn the nut that doesn’t have the threads exposed. I would guess the