开云体育

I am curious what limits the E835xA PDNs to 300KHz and if there is a way to override it, with the understanding that the performance would be reduced?

Paul, thank's for your answer. That’s the problem, I’ve never been able to display a signal with the RF plug. In fact, my first question was whether this catch was smeared because you can’t see

Hi all, I've noticed that my 3457A has two settings for the mains voltage. One is a circular selector with a flat head screwdriver slot, the other is a pair of sliders. I need to change it from US to

Hi From the video it appears you are not putting the test signal into the RF input why ?? Also best advice is to get a few adapters and leads rather than putting signals in with a bit of wire Regards

I have the BTS laptop utility. It works perfectly on my 8935, but I can't get it to work on the 8924. I use the 8924 more because of it's auto-ranging feature.

Good advice Bruce, this is my initial findings, I will study more carefully.

I remember there being a variable resistor with fixed resistors that needed to be changed only if the variable did not provide enough range. Think I'd read a bit more B4 proceeding. Cheers! Bruce

Hi! I am selling two sig-gens and constellation analyzer: - 8656A uncal, some scratches, no option, working fine, accurate and clean wave generation. 4 key springs missing, but working fine. Original

Hello, I luck to found one HP 11708A Reference Attenuator for the 8484A power sensor, one god 30dBm attenuator is ok to use? Thank you for your help. Francesco. G7OYO

Looking for a handbook/service manual for same- ebay prices far too steep. A pdf would be fine- but it's not listed at Artek. DaveB, NZ

I found the 1dB adjustment in the manual The 1dB step adjustment procedure in the manual involves fixed resistors which I must swap to adjust, the test calls for clipping the trace on the top of the

I dunno, maybe by the time I got them in the mid to late 1970's they were either not making them like they used to or I was too advanced by then to be all that interested.? ? ? ? ?Jim Ford?Sent

As I remember, it is easy, but there are several adjustments that should be done B4 if you want the thing to be overall accurate. I think you can just touch up the attenuation and get off with out

The replies are appreciated. I will study the manual and if it is simple I will attempt to adjust it.

Things of Science. Yeah, absolutely brilliant kits of various things covering all sorts of science topics. Loved getting it as a kid. Those little blue boxes were eagerly opened and the educational

Same here with 10MHz output from my HP 8665A. >

I just ran that scenario on my 8566B and the trace does not start to fall off but tracks the sig gen output all the way. Steve WB0DBS

The following files have been uploaded to the Files area of the [email protected] group. * /0000 to 999/HP_330B_330C_330D_Tech_Data_Sheet.pdf (

You might check the catalog at probemaster.com These are not Agilent/HP probes, but their own OEM designs, but there's some chance that they will have accessories which will fit your probes.? I

This is most probably an 8566 adjustment problem. Look over the adjustment procedure and you will find a section where the attenuators are adjusted. I'll try to find time to look up the exact section,