开云体育

Ah, thanks for that!? I shall try messing with the cable length then until it takes off ...? 1.9nS is arounf 400mm of cable at vf=0.7 ... the one shown in the manuel is much shorter, so maybe it is

I have an HP 16500C logic analyser. Actual unit tests fine in the diagnostics but unfortunately the two 16557D cards in it have suffered the green death and fail diagnostics. Does anyone have any of

While all of the liquid suggestions may help, you? may want to try one or two mechanical hacks.? Beg borrow or steal an "easy out" ( a commercial version of the previously mentioned cement nail)

Hi Matt, I don't know if I have a picture of what is inside the copper box but I built an attenuator with SMD resistors. In one leg of the pi-network I also added a 50-ohm matched tap to take out the

In the general case, higher velocity air will drag more dust with it so if no dust filter, then fan should exhaust the enclosure. [email protected]> wrote:

"Ozan" <ozan_g@...> writes: Hi Ozan, I'd be interested in pictures if it's easy for you to provide them. How were you able to trim the cable? Presumably, to test it you need connectors on

A or B? The B EPROMs are on ko4bb.com, at least for "Option H18," whatever that is. I don't think I've seen the A firmware floating around. I just uploaded the standard 8970B firmware. Thought it

Your average big box store (around here) or pet supply store has filters for air systems or litterboxes.? Those filters are granulated carbon and relatively inexpensive.? Air filters for HVAC

Is it a different material than heating vent filter (or activated carbon vent filter for black color) ? Ozan

I went to a local foam supplier that hasdifferent types of open cell foam...cut thickness desired..or use a sharp serrated bread knife and slice off what is needed from a block....trim to

The filter foam is called reticulated foam. It's sometimes sold as fish filter foam (even though that's filtering water) but it doesn't follow that all fish filter foam is usable for air filters. It's

The filter foam is called reticulated foam. It's sometimes sold as fish filter foam (even though that's filtering water) but it doesn't follow that all fish filter foam is usable for air filters. It's

You can buy it on Ebay, and from industrial suppliers. wrote:

I did extensive numerical studies and found I could invert the 1D heat equation for multiple flows such that the prediction accuracy was 1-2% error for a period equal to the recorded data. That

Hi Robin, I built such a cable. As you said output is 11dBm-13dBm, input is 1dBm-4dBm level. Cable needs to provide ~ 9dB attenuation so that the output after going through attenuator provides >=1dBm

Probably because the filter material degraded with age and fell apart; then was not replaced. Can’t suggest where to get it or what alternatives there might be. It may also have a slight benefit in

Thanks to all. I did not expect nor rely upon WD-40. Kroil ordered arrives on the 20th. Appreciate the recommendations re the knob and, unless Kroil or other method to extract the set screw is

Kroil, or Kano Kroil, is a very good penetrating oil that has been around for decades. If the knob is Bakelite or other material that will not melt, turn the setscrew hole upward, put a couple drops

Hi, I have an HP 11729B that looks an anwful lot more like an 11729C, complete with the 640 MHz input (BNC) and output (SMA) ... as you may know you can apparently link these two together to use an

Indeed, the dust filter is a good argument. My box only has a finger grid, though, no dust filter, but lots of dust inside... Tom