开云体育

The close-in spectra of both my HP8656B and 8657B signal generators show 100Hz and harmonics sidebands at levels of -50 dBc, gradually falling away up to 3 kHz offset. The 8657B, which is somewhat

The reason the 10 s stability is dominated by the OCXO is that the GPS feedback loop is much slower, so it won’t do anything useful at this rate. People have been characterizing 73090 OCXOs, e.g.,

PS : The builder states that this unit runs Lady Heather in it`s firmware wrote:

Hello Carsten. Interesting that you say that it`s the OXCO that is the determining factor, not ,for example, the number of satellites aquired, or something else. I shall store that snippet of

For 10 s, that depends almost entirely on the OXCO in there. You may find more info about that. Which one do you have? Did you try looking at it with a tool called “Lady Heather”? This one is

Peter, can you post a picture and/or PN of that bad YTO? I can actually recall at least three YTOs that were used in the 8970. The last version is a small one, Agilent standardized on that YTO for

That's usually the function of the bid size.

I`m hoping that there are members of this group who utliise the above serial number Trimble PCB as a frequency substandard for their H/P equipment, and know the accuracy that can be expected from this

Yep.

Are you talking about the soft key cover?

I just realized I wasn't specific enough, sorry for that, but I hope the image I attached cleared up any confusions.

The cover itself, it goes over all the buttons.

Son of a gun. The unit is working! Peter

Which button?

Google "bidder collusion"

Hey guys, I'm missing the button cover on my HP 8752C. I know I'm not the only one with this issue and I know they're close to impossible to find. Is anyone willing to measure it and take some photos

Resistors can be bought from Digikey, Mouser and others.

IF Cal… Pete

E80… memory loss. Replace battery and do an if Cal (11.1 SF I think… one of the SF's anyway) 15 dB enr ns must be attached.... All will be well. Pete wa2odo

Do you happen to know which 8350 plug in uses that VTO?