开云体育

Hello Roy, apologies for a lack of clarity on my part. Before John Miles designed the PhaseStation 53100A he produced the 5330A TimePod, ?later marketed by Microsemi which was an excellent

Thanks so very much.

Mark and Robert, Go ahead and make a deal if you can. I have already purchased a couple of the missing items. Thanks

Hi Robert, I am interested in that if Michael isn't. Thanks! Mark

The following files and folders have been uploaded to the Files area of the [email protected] group. * /All HP, Agilent and Keysight instruments in folders by part numbers/000

Hi Michael, The parts you need are no longer orderable from Keysight. When they were available the prices were very high. I have a used set of handle, front bumpers, rear feet and all screws. The cost

Hello Michael 4mm screws for the Handle stuff 3mm for the front bumpers 5mm for the feet of the correct lenght I think 50mm best regards Peter OZ1LPR ________________________________ Fra:

All, Recently purchased an 8920, but it was/is missing the bottom feet, the front bumpers, and the handle (the metal swivel parts for the handle were included.)? I am working on sourcing the parts,

The following files and folders have been uploaded to the Files area of the [email protected] group. * /All HP, Agilent and Keysight instruments in folders by part numbers/000

HP 546A Logic Pulser uploaded.. (

OK- Will do later today. Cheers DaveB, NZ Sent: Friday, November 10, 2023 12:44 To: [email protected] Subject: Re: [HP-Agilent-Keysight-equipment] HP Service Manual -

Hi Dave - many thanks for your offer. I’m after a good quality pic/scan of the replaceable parts list page for board A7 (IF amplifier option 010) thank you Tony

Tony, I have a hard copy here- dated Sept. 1982. Don’t have time to scan it ALL just now but if I can help with a few scanned pages let me know. Scan of title page attached. Dave B, NZ Sent:

Hi, Does anybody have (or know the location) or a reasonable quality scan of the HP 3730B Down Converter service manual? There are several manual available on the internet but they are all generally

One of the tricks on old equipment is to power the eprom from a separate power supply and adjust the voltage up or down until the checksum passes, then copy that data out and burn a new part. Don't

"vk2bea via groups.io" <vk2bea@...> writes: Excellent! Thanks Michael. Looking forward to the 546 and 547 too. Matt

I have the 545A, 546A and 547A. The manuals from HP are of poor quality. I've just done a scan of the 545A and uploaded it. (

OK Yves....Thanks for the ?TP diagrams and wave forms, I'll try to find the failure. ?Nice scope! ?About 30 years ago I had and HRO-500 with germanium transistors that had a phase lock loop that

Yes, you're right, I didn't notice. I would create new pieces but no image available.

P27128A is an EPROM - you can't flash that. Get a new empty one an use a programmer. Am 09.11.2023 um 15:14 schrieb David ?áda: