开云体育

There is a rather simple solution: Scan only the oversized pages. Typically, the theory sections only change slightly over the life of an instrument. You could scan some of the sections referring to

"Richard Parrish" <Richard@...> writes: Thanks Richard, it's generous of you to be open to this. I've looped in Dave at Artek who scans these manuals as a busi

I'm sure that these are rare. I was in a place 10 years ago that I was able to purchase a number of the end-of-life manuals with all the updates, expensive but I thought it worth it. I couldn't do it

"Harvey White" <madyn@...> writes: This is a good point. The current through R23 when off is in the low nA range, same as when the instrument is powered on. This seems to be consistent

Just looking at the schematic, I wonder about a few things: did you measure the current through (or voltage drop across) R23? This would be both in power on and power off. I'm assuming (as a fault

"Askild" <megafluffy@...> writes: That's correct. Measured at the battery terminals with a >10GOhm input impedance voltmeter. Instrument off and disconnected from line. Also correct. I used an

Hi, I have a version for serial number 2251A and 2309A. This is the original hard copy manual. If you need a particular section of this manual, I can scan that part and return it to you as a PDF.

I am looking for the 8350B service manual for S / N prefix lower than 26XXX, I have P / N 230400-216, on the net I find only the print of October 92 with P / N 08350-90092, I need the one printed

Hi Matt, I don't know the 8970B, so this is just my general thoughts. Just to verify that I fully understand. When you measured the lover voltage of the replaced battery, this was measured at the

Files uploaded "Tantalum, film" should be "tantalum, foil" - typo and changed in file. Hal

I’d be happy to support that if it is possible to get it scanned. Tony

"Richard Parrish" <Richard@...> writes: Hi Richard, It's great news this manual still exists. I spent a while looking for this, including asking Keysight and a couple second hand vendors and

I received a faulty HP 8970B displaying errors (E80 and E26) related to backup battery / attenuator calibration data troubles. I measured the voltage across the 3V coin cell in-circuit to be about

I picked up the unit with total cost about $71.50 incl shipping. Hope it works

Thanks Andrew. have you used any freely available Keysight software for automated measurement using these oscilloscopes qith non-GPIB interfaces ? I just invested into ethernet/GPIB for the other

On Fri, 3 Jun 2022, Andrew Hakman wrote: There is one for $55 BIN on ePay right now: https://www.ebay.com/p/1801528248 There is one more but that is in South Korea with asking price of $300 and $90

I had a saved search set on ebay for at least 2 years before I found one (at a reasonable price). They seem pretty rare, especially on their own and not with the scope

Harold, what’s a “tantalum, film” capacitor? Sent: Friday, June 03, 2022 8:49 AM To: [email protected] Subject: [HP-Agilent-Keysight-equipment] New file: Sprague capacitor

Hello, I wanted to standardize on GPIB for my HP/Agilent/Keysight instrument collection and realize the MSO didn't come with GPIB. I think per the manual an old N2757A is probably useful to do that.

Thanks, I bit the bullet and order a new ProLogix ethernet/gpib dongle. The manufacturer has raised prices, and they recommended that I buy from vendors wirh existing stock, currently selling at the