开云体育

Here is the schematic of my unit. It does not make a lot of sense to me. Any thoughts? The diodes I understand, the 20 ohm (0.27 ohm according to the parts list) I don't, especially the one off the

Does anyone have (or has drawn) a schematic for the 16047B test fixture used with impedance analyzers? Mine seems to have modifications. There is a drawing of the insides in the Operating Note

Oh-- De-oxit/Cramolin on the sockets was necessary to finallyget a .0001+/- zero reading.J

I did receive a set of those clips, and found it necessary tosolder the 4mm expansion sleeve/banana part to the base ofthe plug so it doesn't spin and make poor contact.? The meter will not zero

I have a set on order and will report when they arrive. Jeremy

david.partridge@...> wrote: Is this true? I don't think groups.io auto-deletes attachments any more than uploaded files or folders. The only mention of deleting attachments on their site is

If enough people tell me that this works, I'll ask the moderator to see if we can put it in files. Although it worked fine for me, I would like some input before putting it into files. If anyone uses

I, too, would like some pictures of Option 002. Perhaps they can be posted in the Files section. Thanks. Joe Sent: Thursday, April 04, 2019 5:09 AM To: [email protected] Subject:

From: Chuck Harris <mailto:cfharris@...?subject=Re:%20Schaffner%20explosions%20%28Re%3A%20%5BHP-Agilent-Keysight-equipment%5D%20HP8657B%20Mains%20Filter%20Disaster%29> Date: Wed, 03 Apr 2019

That would be awesome if you could take a few good photos. :) I have a source on the power connectors, and the signal connectors look to be just RCA style, so they should be easy to find too. I think

Hi, I was recently thinking about the same for my 3325B, but ended up buying a non working 3325A with the option and just transplanted the option. This has the advantage that you get all the

Hi, I have just recently picked up a working 3325A Function Generator, and am thinking about building my own Option 002 board (High Voltage output board) to give me 40v output capability. I had good

70590A H69 is supported from 70900A version 861015 (MEM+ hardware) . --------------------------------------------

Attachments may vanish after a while. far better to place something like this in the Files Area in an appropriately named “Folder”. David Sent: 04 April 2019 04:46 To:

I bought some which look identical to that, and they didn't work. I demanded and eventually got a refund. The symptom was that on one of the leads, when measuring the resistance from one 4mm plug ->

“Put it” as in make a FAT32 file system on the card and load the files on it? Grü?e, Carsten

Here is some CPU fan information. The same processor board is used in the 8720ES where the fan is: SUNON KDE0504PEB2-8 5V dc / 0.4W The fan and heat sink on the 8720D may be different, so this

Let us hope this file is not too big This is the entire Full625 upgrade with the freq/time GPS patch already done Just unzip and put it on a PCMCIA or CF card and boot the e7495 If anyone tries this

I believe it is supported in conjunction with a 70900A. I won’t have access to a large-format scanner for a month or so, so I can’t scan the schematics. But I have scanned and will send you the

My chinese Kelvin test leads finally arrived, and they look & feel very good and solid. As usual my 3468A almost reads zero altough still a bit negative when I short them out. But I am pretty sure