开云体育

Thanks, Dave . I just wanted to check before taking on another small job! Pete

There's a note in the file saying " Apparently the new memory board has a lithium battery installed which it says is good for a few years. It might be an idea for anyone with a B version to check this

I just uploaded my modification to be used at your own risk. Batteries can explode if incorrectly charged.

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the [email protected] group. *File:* 8566A Battery.pdf *Uploaded

So there is some doubt… ? Pete wa2odo drkirkby@...> wrote:

Hello, Stephen that would be great. Thank you! Sent from my 20" Texas sized iPhone....

The programmable logic chip companies never release their timing details or even the commands to interconnect at the RTL level of a design. So after you feed their tool a RTL design, you get back a

I can make a board layout with open editing tools -- I have even used my own footprint for QFN48 packages with good results fabbing. Anyone else on the list interested in supporting that effort with

My experience with a HP 70900A LO and a similar range YIG (ie, not correct part number) from a signal?generator of the same era was that I had to play with the resistor divider (DC) network to get it

99.99999999999999% sure it will be LCR. My 8720D is, as is my 8753ES. Dave -- Dr David Kirkby Ph.D C.Eng MIET Kirkby Microwave Ltd Registered office: Stokes Hall Lodge, Burnham Rd, Althorne,

Hello, this is very valuable - sadly, I am in the middle of the tax war at the moment. Do you mind if I post these to my Instagram to preserve them? Ta, With best regards Tam Hanna --- Enjoy

My initial awareness of the AD eval boards was through a QEX feature article about a 16 bit 100 MHz BW direct sampling SDR built using an AD eval board and a Zed board for ~$1K BoM. I signed up to get

Can anyone tell me if the 8719ES VNA has a CRT or an LCD Display, please? Peter Worrall G4GJL

If possible it would be useful if you could provide an image that people could use to create a disk. Ideally with some open-source software! I would rather see instruments being properly used rather

Of course, there is the HP Journal discussion of the design of the 4396B from YHP. https://www.hpl.hp.com/hpjournal/pdfs/IssuePDFs/1993-10.pdf

I have opened the 41951A impedance test kit a while ago to see how it was constructed. But there is really nothing fancy inside. Some inductors, a few caps... I uploaded the pictures if anyone is

The issue is the contacts as it is a drop in pack but I’ve rebuilt them by resoldering those to the weld tab if you’re quick nothing gets too hot at the battery! Adrian Sent from an I-thingy

Just a note on the Gigatronics 1026 generators, when working they are pretty good generators - 0.05 mto 26GHz. Harmonics and spurs are almost nonexistent in these units. Flatness is on the order of 1

Entry error typo due to excitement: "...even more exciting is if a decent board..."

I have a couple of HP and several avantek units. I’ll check the on in the morning Regards, Stephen Hanselman Datagate Systems, LLC 3107 North Deer Run Road #24 Carson City, Nevada, 89701 (775)