开云体育

It's a risk to the seller, not the buyer. If it's a stolen card, you can get a chargeback months later, and have no recourse.

Why do you say "foreign credit card transactions are a huge risk?" Lots of people make foreign credit card transactions every day to people they don't know. If the risk was considered huge, this would

I am looking for a test set for the 8753. Ideally I'd like to get a 85064A which has blown couplers or a B. I'm going to be doing some mods in the thing. I could even use a 85047A with blown couplers.

That may be, but it has been all over the news that if they request wiring the money it is usually a sign of a rip off. I avoid anything that looks the least bit fishy on the internet. Too many scams.

Look at it from the seller's point of view... foreign credit card transactions are a huge risk. Why shouldn't they require a form of payment that's safe for them?

Wiring the money is a BIG RED FLAG. Stop, turnaround, and never come back. Steve Bob Stewart wrote:

I thought you would. I think most people who own a VNA will at some point want to measure a two port device like a filter. I sometimes want 3 and 4 port devics, but for what I want (directional

Has anyone got one of these they want to sell? If so, please let me know your price and send me some pictures. I want to see: 1) Overall picture of the complete kit. 2) Individual parts 3) List of

I wouldn't touch it.? In fact, I wouldn't touch anything that wants me to pay in the equivalent of cash poked through a slot.? However, I've never dealt with them. Bob

I'm looking for an HP 85054B type-N 18 GHz calibration kit. A company called Eglink in Korea says they have one, but they want the money wired, and I'm not keen to do that. In fact Firefox wont even

I really don't know the current. The manual specifies the voltage as 6.3 but no current spec. I'm guessing 150 mA. There is nothing but a Boonton part number. Regards. Max. K 4 O DS. Email:

Dear All, I wonder if you can help me with the spare parts needed to move the RF-Output (hp 8657A, Option 002 Rear Panel RF Output) to the front panel. Probably you have a parts unit, so that you can

All, Having gone as far as I can in my attempts to upgrade the RAM in my 16500A logic analyzer, and found that it's a dead end with the early CPU board it has, I would like to fit a later CPU board to

Try looking at, or calling, one of the internet bulb companies, like BulbsDirect. You'll need the voltage, current, and OD. They should be able to help. Good luck, -John ================

Hello group, Recently I sent a post about a problem with my digital multimeter – malfunctioning when measuring resistances. It shows wrong, higher than expected values and was very slow to react.

They have wire leads which are soldered to terminal strips. Regards. Max. K 4 O DS. Email: max@... Transistor site http://www.funwithtransistors.net Vacuum tube site:

It very much depends on the measuring current too. But for an 478A measured with an ohm meter that sound ok to me (from memory...). Should be similar to a single 477A, no? ? 73 de Harke

Hi all, I'm trying to rescue my HP66319D power supply. The trouble seems to be in an analog section, since I can still program voltage & current. Under load, the output still delivers the juice (even

Jay: Indeed, that was the goal. And after I did that, I found that the file I had recovered was not an ASCII file, but a hex encoded tokenized basic file. This file was just as it was on the LIF

Hello, All. I would like to call your attention to two of my auctions on eBay. One is for an HP 8900C analog meter with an 84811A power sensor and cable and an 8900D, also with an 84811A power sensor