...Another solution that I am considering is to buy a microwave SPDT switch (even SPST can do)
and put it between the attenuator and the input of YTF. For the high band the switch will pass the signal to the SYTF and
it does its job perfectly but for the low band the switch will divert the signal (pass through) directly to the dual mixer.
The biggest issues are generating compatible switching and power supply voltages from what is already on the A7 board
for that I will have to put is some transistors and stuff somewhere! and the next issue is where to mount the switch in the RF compartment.
There are some small spaces here and there and maybe I can squeeze it somewhere...
However, the type of the switch is critical. First I was looking at relay switches for example from Teledyne which have
extremely good specs and relatively cheap but then it struck me that the switching times must be very small compared to the sweep speeds of the SA
Relay switches are rated at 5ms-15ms switching times. The might work OK for most of the time but if it happens that your frequency span
covers the transition between low band and high band and the sweep time is in the range of 10's of ms then it becomes a mess...that's exactly why?
the HP designers only used PIN switches in all places in the RF section. Modern analyzers use GaAs FET switches. The switching times for PIN diode switches is?
around 5-20nsec but of ocurse the can never achieve the insertion loss and isolation specs of relay switches. not even close..
Now the only thing I have been able to find was Minicircuits ZYSW-2-50DR and ZYSWA-2-50DR with reasonable specs up to 3GHz and even applicable up to 5GHz but not to 6.5GHz as I need.
Any suggestion about a PIN diode RF switch that I can buy at reasonable price is welcome?
