Chuck;
Attached is a part of an 8754a sales brochure dated 1 JAN 84.? Note
that the section on the 8501A states:
"A single internal adjustment (DAC Gain) is required for 8754A
compatibility".? I respectfully point out that I did read the HP
Literature before deciding that the 8501A was compatible with my
8754A.? I don't know if the image will be displayed, but a scanned
image portion of the sales brochure is included below.
Mike, I would like very much to make a copy of your manual.? I do have
both a sheet feed scanner and a flatbed scanner.
My callbook address is correct, and I was wondering if I could PayPal
you the postage?
Gary
NZ5V
Chuck Harris wrote:
toggle quoted message
Show quoted text
The HP catalogs only say that the 8501A works with the 8505 network
analyzer system.
The 8501A also is special in that it is setup to normalize both the
polar display
and the phase-magnitude display of the 8505A.
As further evidence of my belief, HP sold both normalizers at the same
time.? In the description of the 8750A, they list a hand full of
instruments
that are compatible.
-Chuck Harris
Gary Peterson wrote:
> John;
>
> You are so right!
>
> The 8750A must have OPTION 1 installed in it according to my 8754A
> manual.? It's a special interface card, and of late one was on
Ebay.? I
> wanted to get the 8501A working because it has the HPIB interface,
and
> the 8750A does not.
>
> Also, I think my analyzer needs an adjustment to work properly
with the
> 8501A... hence needing the manual, as my book does not do more
than
> indicate that I have to adjust something!
>
> Gary
> NZ5V
>
