Thomas, I managed to find my NI AT-GPIB/TNT card and got it working
(I think.) Actually the driver setup from NI is pretty good at
telling you the correct jumper setup. When clicking on the
autoscale button inside your application, I get the following error
dialogs:
Unable to write to device ibsta=$8100 iberr = 2
lbsta ===> ERR CMPL
iberr ===> ENOL
Any ideas anyone? In the NI gpib explorer the scope shows up in the
list, and will beep when I try to send a command thru the NI
interface, but the scope will say WARNING: waiting to recieve data,
then the NI program will time out. I have a suspicion that I am
able to send commands to the scope but cannot read the responses
from the scope.
Regards,
Bob
