I pretty much just follow this guide:
Which can be confusing at times (wording is not totally clear at some points). Especially after you create the control points, you have to do this strange zoom, move, and crop, and hope everything turns out OK. And the preview it creates durng the process will look like crap- you have to remember to click "Calculate Optimal Size" at the end.
I have definitely had Hugin not connect some schematic lines before, and some schematics have been completely unsuccessful using it, but have had successes elsewhere. To my knowledge, it hasn't connected any lines incorrectly, that could be a control points issue.
-Michael
On Thu, 20 Feb 2025 at 07:14, Michael Bierlein via <bierl008=
[email protected]> wrote:
I use software called Hugin. Bit of a learning curve, but works semi-reliably after you get it down.
I've tried hugin for schematics, and was unsuccessful: many of the continuous lines were no longer continuous, and it connected some lines incorrectly. What settings did you use for the stitching?
