开云体育

I found the main power supply issue, a blown capacitor in the HV section, one side to ground. Unplugging the tubes was not enough to exclude the HV section.
From the schematic?

I notice that the blown capacitor C112 has a sister one C111 , same value, according to the component list 0.1 uF


if I measure the good one i get a 3 times bigger value? (this Chinese res/cap/ind/diode/transistor 3$ is amazingly useful)


?and the resistor in between measures 45 ohm instead of 100. Can anybody read the capacitor color codes?
Reality is different from the schematic , the manual is for mod 25 to 724, mine is N 2482
I am tempted to go with the schematic and replace the original capacitors with polyester ones I already purchased, .1uF 650V, am I doing the right thing?