开云体育

Thanks Adrian, you got me back on track.

I did try bending the clips inwards but it wasn't enough. Thinking on your advice, with a dental tool I was able to get some leverage below and the clip lifted out on one side. It was then obvious the two small posts were all that was holding it in place.

Regards

Lou

VK3ALB

On Sun, Apr 28, 2024 at 7:36?PM Adrian Nicol via <Adrian=[email protected]> wrote:

Interesting, not seen that before but I very much doubt it could have been 'threaded' over the pins of a through-hole socket - so I would guess it just has not got a full length bar underneath?
Most likely just small ears catching under each end of the socket - have you tried simply gently pushing the end of the clip inwards or using a small screwdriver to lever the bottom of the red clip outwards?

On 28/04/2024 10:21, Lou Blasco wrote:

Hi all,

I'm installing a NewScope LCD in a HP85662 and part of the job requires a distribution PCB to be plugged into this socket. Does anyone?know of a way to remove the red retainer clip without damaging?or desoldering the socket ?

Regards

Lou
VK3ALB

Attachments:

• image.png