Re: low amplitude readings below 10MHz on a 8591E
Hi Mike its? 10dBm above the ref lvl. with 10 db ATTEN
Gr. Kees
toggle quoted message
Show quoted text
Gr Kees, Did you take a look at the 0hz feedthrough amplitude ¨C(left side of display) What value ?is it? Mike ? ? ? From: [email protected] [mailto:[email protected]] On Behalf Of KeesHofwegen Sent: 20 March 2023 19:28 To: [email protected] Subject: Re: [HP-Agilent-Keysight-equipment] low amplitude readings below 10MHz on a 8591E ? Hi Mike, I've backup the constants ( paper) and used my marconi frequency?generator?to have the amptd NOT fail. After that the cal signal of the 8591E was used to do an amptd again and this time it succeeded. Still the lower end is terrible ( low amplitude ). I've done the service diag and? 1. the MAIN Coil driver?is much steeper and starts higher at the -20dbm horizontal line? The rest has the same picture as shown in the?8590-90316 manual. So according to the manual it's in the A7 board. does somebody have a spare will to sell ? Hi ?in your case ?from 238-247 if you haven¡¯t done it already? ..201 onwards? ?backing up correction constants ? One thing to check is the level of your LO feedthrough amplitude ?..the signal at 0hz on the left hand edge of the display Do frequency 0hz? span 1mhz¡ and see what the level of the LO is? --good ones are around -10db or better. ? By the way you¡¯re 8591? is a bit different on the front end than the 8590e series , yours is more prone to mixer failure but can be fixed . Lots of info on you tube ? Regards Mike g4wam ? ? ? ? ? ? From: [email protected] [mailto:[email protected]] On Behalf Of KeesHofwegen Sent: 18 March 2023 17:47 To: [email protected] Subject: Re: [HP-Agilent-Keysight-equipment] low amplitude readings below 10MHz on a 8591E ? got it and will start reading.?
Any recommendations about what paragraph? ? You need 08590-90316? from? 2001 8590 series Service Guide ? Are large tome but worth downloading or buying ¸é±ð²µ²¹°ù»å¡¯²õ Mike g4wam ? ? From: [email protected] [mailto:[email protected]] On Behalf Of KeesHofwegen Sent: 18 March 2023 14:41 To: [email protected] Subject: Re: [HP-Agilent-Keysight-equipment] low amplitude readings below 10MHz on a 8591E ? Hi, Are we talking about the user manual 08590-90301, because there is not much cal data in it other than the normal stuff. I also have the installation, verification & Operation manual. Or are there other manual I need?
|