On 11/8/21 5:58 PM, Matt Huszagh wrote:
Did you make your own supports from angle irons, Dave? It sounds like
getting 1.5 in sq angle irons 1/8" thick and then drilling custom holes
for mounting to the rack could work well here. I expect the trick is
drilling the holes at just the vertical height so that the modules sit
on the angle iron but the flanges still mount to the front panel.
No, I'm too much of a perfectionist (read: snob) (and have too little
free time) to do that. I get proper rack rails, usually Navepoint these
days.
If it's not too much trouble, would you mind sending me a link to the
Navepoint rack rails you get? I think I'm not finding quite the right
thing.
These are the ones I use for most things:
I first spotted them (and Navepoint as a company) on eBay, so I just ended up buying them there.
As I mentioned earlier, they are a bit software than I'd like, but they're otherwise well-made and have been very handy.
-Dave
--
Dave McGuire, AK4HZ
New Kensington, PA
Dave McGuire