Well to be fair, yours was a pretty general question that certainly
applies here too.
-Dave
toggle quoted message
Show quoted text
On 4/7/20 10:02 AM, Dave Miller wrote:
Thanks Nigel,
I have found the IFR group. I should have looked first. ?
Thanks
Dave
On Apr 7, 2020, at 2:50 AM, nigel adams via groups.io
<nigel.adams@...> wrote:
? Have you tried the IFR group as well - there are people who have
this stuff and might be able to help.
------------------------------------------------------------------------
*From:* [email protected]
<[email protected]> on behalf of Dave Miller
<ve7hr@...>
*Sent:* 07 April 2020 03:55:29
*To:* [email protected]
<[email protected]>
*Subject:* [HP-Agilent-Keysight-equipment] Hints on removing burned
tantalum residue
?
Not directly HP related but this is where the knowledge is.
I am starting to repair an IFR-1200S that had an incident.
<IMG_0884.jpeg>
<IMG_0886.jpeg>
A 150 uF 15V tantalum went up in smoke.
What is the best solvent to remove the residue on the rest of the PCB.
Isopropyl does not take all of it off? Want to get it all clean before
I replace parts and continue the repair.
Thanks
Dave?
--
Dave McGuire, AK4HZ
New Kensington, PA
Dave McGuire