HI All..
I just obtained an Agilent DSO-5012 which I thought would be a great scope for getting familiar with the use of Digital Scopes. I understand the principles of sampling etc., so that is not an issue.
The scope seems to so far work correctly, the time base and voltage reading for the two channels are correct.
?
There is a User Cal function when initiated, that almost immediately stops. Message indicates it should take 7 minutes.
When I received the unit, the User Cal Status indicated ¡°Failure: Digitizer, failed,? int for talon cal, setup chan1¡±. ¡°Comments: PANTHERT8¡±
The same is indicated after I initiated the User Cal following all the directions for required cable connections etc.
?
I use to repair test systems, test equipment as part of my carrier and would like to tackle this but of course there is no real information available from Keysight/Agilent, aside from the limited Service Manual.
?
Does anyone out there have any information that may help me figure out the failure path?
?
°Õ³ó²¹²Ô°ì²õ¡¡..
John
