Hi,?
For telemetry view download and run SM0ULC python script, where you will see what channels in use at the moment as the program scrapes wspr database for "hab channels"
?
In the original setup Eduard used that reset supervisor mic2775 so should be good, Im just using the brownout setting in the 328 so I cant comment on that component
As a highside switch I belive? mic94092 was used in the original build but its just about the same as the 93 so it will most likle work just fine.
/Mikael
Hi,
I didn't figure out why such wide signal but on 10.1mhz is decode 400km away that is good. On 14MHz I'm still trying.
How do you know for which transmitter is the telemetry,? only with channel selection?? I tried to find on WSPR map webpage but is not easy
to find the telemetry data. Is any shortcut how to search telemetry of individual channel?
For switch and reset I found only parts mic2775-22Bm? and mic94093yc? are that ok too?
BR Jan
toggle quoted message
Show quoted text
Hi, no I have not seen that on my builds and I have been running them for countless amount of hours.
Im guessing you will insert the switch at some point, if you try to run the board without it it will likely have problems starting with solar power, you can easely test this by putting the board out in the morning as the sun comes up.
/Mikael
