Re: HABalloon Project
|
col_bob_bush
Hi Jan? It is totally normal if you look at my screen you will see sometimes?3 copies of packets 100hz apart This is caused by your receiver overloading by a close by transmitter and making extra images that are usually 20 to 40db less than?the main signal In the screen capture you may see I am testing 2 transmitters at the moment 2x -13 balloons? What you need to do is make sure you are on frequency with your receiver and why are you not hearing other wspr stations ...check your beacon antenna? and make sure you use a 50 ohm resistor on your beacon if you do not have it connected to an antenna. And check your wspr receiver antenna you should hear other stations at the same time. If your beacon has a gps make sure it can see the sky to get the timing correct wspr has to be exactly on the minute to be decoded. Your reports show it is on time but the fact that your radio does not decode other stations shows a problem. Dave On Wed, Nov 25, 2020 at 2:46 PM JanV <jan.vadilijev@...> wrote:
|