开云体育

Do you have an initiator set for CLASS=C? All your job cards for the IOGEN are set up for class C.

Right. Tried this. First I created a JCL job that created the OBJPDS datasets:

Yes it is applicable to an IOGEN as well. Joe

Reading the instructions in the TK4- manual it looks like this takes place AFTER IPLing the new TK4- system. Not in the starter system. Step 10 - 12 above. Using the excellent pages that Jay Moseley

Nope. The nucleus doesnt know how to do DAT on any address greater than 24 bit. Joe [email protected]> wrote:

What if we were to add Amode=31 and rmode=any to the assembler code then we did the Link-edit in 31 bit mode also.? Do we end up with a 31 bit mvs38 system then? regards; Rahim

Mattis, The other thing you have to remember is that you are generating a new nucleus. So, you have to apply all of the service and mods that. were applied before your did your IOGEN before you can

You have SYS1.OBJPDS in your JCL, so you'll need SYS1.OBJPDS01, 02 and 03. Joe

Why isn't the picture included?? https://i.imgur.com/Z5ZZBS7.png

I think I found one thing that I haven't done. According to the sysgen manual I define three utility data sets. But I simply don't understand what all this means. It says in the Figure 37 text caption

Hello Joe, Here is the stage 1 in put file: https://drive.google.com/file/d/1SWqCcaLmhKQmNKfV5uer4xm5sumTtTe3/view?usp=sharing It is almost identical to the one in TK4- except for the first 2703 at

Mattis, Looking at the IOGEN.JCL you submitted, there are no 2703 devices. Can you attach what you fed into STAGE1? Joe

Hello All IOGEN experts! I want to change on of the 2703 devices in the TK4- config to act as a BSC3 device so I started to try to do an iogen on tk4- and failed completely. The steps described in the

Super job Bob, congratulations ! Cheers, Peter

NJE38 version 2 is now available in the files section (nje38v200.zip). This version now contains the much-needed TSO-based TRANSMIT and RECEIVE commands. These commands allow you to send and receive

Found it in GC23-0002-0 "OS/VS2 System Programming Library: JES2" &RJOBOPT controls scanning of JOB cards by JES2. Changed from 5 to 3.

I am working on some SMF reporting w/ MVS 3.8j. SMF type 4, 5, and 20 records (step termination, job termination, job initiation) all seem to have the accounting information in them (pano and room,

Hello Doug, Am 20.07.2020 um 23:47 schrieb Doug Wegscheid <dwegscheid@...>: You did miss it. :-) https://bsp-gmbh.pocnet.net :wq! PoC PGP-Key: DDD3 4ABF 6413 38DE -

thank you.

See: /g/H390-MVS/message/1346 https://bsp-gmbh.pocnet.net/