On Fri, Mar 22, 2024 at 07:14 PM, madastro wrote:
Folks
I have successfully run a PemPro 3 session - 12 worm cycles - created a good PEC curve and am now trying to load it to the Gemini controller but keep getting serial port comms errors and serial port timeouts.? It looks like PemPro is trying to write the curve data out too fast?? Any ideas?? Gemini log file attached...
Regards
Mark
Hi Mark, you are getting a lot of communications errors in the log, long before you try to program PEC. You may need to replace the serial cable, or the USB->Serial adapter, or both.
Regards,
? ?-Paul
Paul Kanevsky