Hi David et all,
I may have misspoke about the stall message..the HC said also "heavy lag", so it is as noted the Gemini does not know where it is.
Michael shared with me his troubleshooting expertise. I swapped the cables.and found that the problem still existed with a different cable. One down.?
I then swapped the G2 controller outputs, and I found the DEC motor runs fine when connected to the RA output. Shoot! Saved, as mentioned, $500.
So it's the motor. I found something interesting on the Losmandy store/replacement parts: 'Stepprr motor PC Board". Could this be what's fried??
In any case, I am anxious to get up and running again, butI am awaiting Losmandy response to repair request.
BTW, it seems I memorized the RA and DEC backeards, do that may have been the cause of my Ozp! Would be funny if it didn't hurt in the wallet so much.
Clear Skies,
Paul
