开云体育

Thanks a lot, Rene and Paul, the Gemini is up and running again! The handcontroller looks fine but the web page is a bit rudimentary:? What other files are required/recommended for a fully function

Hi Erik, try doing what René suggested: copy the *NewGem.bin* file to the SD card using a card reader, and rename it to *HGM_Gem2.bin* , then put it back into Gemini and turn it ON. This should force

You discovered the secret to creating a model, 3 stars or more will create a good model, if you get good enough star visibility to do more than 3 this should improve accuracy however 3 should do it.

Hi again, I see I left out a possible important thing: When upgrading to 6.1 I first attempted uploading the NewGem.bin file with Gemini by way of FTP. Then I tried activating the new firmware through

Hi Erik, Please format a SD card and copy the Newgem.bin file onto it. Rename it to HGM_Gem2.bin. Put it into the Gemini board's socket. Power on and wait for about 30 seconds. Then plug the HC into

Hi group! First posting here from a longtime lurker. I bought my G11 with Gemini II new 4 years ago and have been using it sucessfully ever since. This summer I also managed to upgrade to level 6: PIC

I finally had a clear night. When I had the problem there wasn't a lot of stars to align to because of trees so I was just using two stars going back and forth between the two. That was my problem.

I know I'm late to the party but my favorite thing to do is connect the Gemini 2s to the home LAN using Ethernet and then map the Geminis using Windows File Explorer.? This allows you full access to

Now that is a lovely mirror cell!? This counterweight tip works for large triplet refractors too where the focuser is a smaller lighter visually oriented model or the refractor is just a poorly

Thanks Chip, I called Losmandy last week and they recommended the pier and RAEXT.? I will get the motors tucked in a few months.? The pier and RAEXT arrive tomorrow.? Apparently FedEX is also

Ah... Great idea Chip, thanks! The rear end of my OTA got much lighter when I went to the Aurora Precision EQ cell but the drawback was that it hung much further down. That is a solid input. Cheers

Never mind, I found it..... Kevin

Hi Ryan, Another trick I have used and something you might consider if your mount is not payload limited is to add some counterweights on top of or behind the mirror end of the tube.? This allows you

Sorry to ask a really stupid question - I see how to upload an individual file to the SD - but there must be a simple way to upload folders. I just spent the last couple hours and can't figure it out.

I just thought I’d mention a clearance issue with my own setup. I have a G11 on a permanent pier with the 4” pier height extension and the RA EXT right ascension axis extender. Thus far the

I use SharpCap too, it works great. If you notice things getting worse as time progresses, it could be your gear is settling in. I usually leave my gear setup for moths at a time. I setup on patio

Thank you Darryl, your suggestions are much appreciated. I'll definitely run the Guide assistant, which I have not done before. I get it regarding seeing and mine is typically fair at best so I'll

Seeing is a major part of guiding. If the seeing is bad, guiding is bad. Get the Astrospheric ( https://www.astrospheric.com/ ) app/subscription it's a great way to see what your night has in store

Great to know! thanks for the clarification.

Hi Ryan, yes, the automatic drift correction is applied when PEC programming is completed. But unless you see noticeable, uncorrected drift after PEC, I would not recommend that you reprogram it. The