Hi group!
?
First posting here from a longtime lurker.
?
I bought my G11 with Gemini II new 4 years ago and have been using it sucessfully ever since.
This summer I also managed to upgrade to level 6: PIC programming the servocontrollers and
wrote new SD cards with firmware for the Gemini and HC. It worked fine, save some missing
catalogs etc on the hand controller.? I almost always run the Gemini from a raspberry Pi4 with
astroberry so that did not matter much anyway.
?
This was were things stood before last night when I attempted ugrading to 6.1, again copying the
new firmware bin files to the two SD cards, using a card-reader as I don't have a Windows PC for the
GFU utility. Now I cannot connect to the Gemini at all: the handcontroller just cycles between
the opening screen - Initializeing HC... - Connecting to Gemini... all over. The ethernet gives no
response either. Even switching back to the original SD card on the Gemini (the one that came with
the unit and that I never modified) gives the same result: for all practical purposes the Gemini appears
dead, save for the red light on the on/off switch.
?
Any suggestion for how to go from here?
?
Regards,
Per Erik
?
