开云体育

Turning off Set Time on connect allowed a perfectly good connection. All working normally AFAICT. This is *most* odd. I wonder how the Sc command isn’t working (over serial port) for EITHER of the

Yes it was! Seems that your Gemini doesn't like setting UTC time. The result of the command isn't received 10 seconds after the command was issued (I actually increased the serial timeouts in the

Paul, the entire log file was in the attachment to the earlier message. The Firmware was 6.05 D. Sent: 25 October 2024 21:10 To: [email protected] Subject: Re: [Gemini-II_io] Serial connection to G2

I’ve noticed 9600bps laggy with Gemini ASCOM. I use 57,600bps on BT and it’s much more snappier. ? I get GEMINI settings pop up in ASCOM almost immediately. At 9600 I’ve seen it take quite a

I recently had my Gemini 2 upgraded to L6 by Losmandy. Set it up yesterday. Had the scope parked but on for an hour or two. Walked away from it. When I came back, the hand controller was in a boot

I've decided for the HC reboot mechanism intentionally, it is the best method to reset all these internals of the ARM processor to a well defined state, of course after trying every other possible

Will there be an updated GFU? ----------------------- Jim W Phoenix, AZ USA

What's the firmware version of your G2? Can you upload more of the log file?

There’s a pattern in the behaviour, just before the timeout in each case we see the identical message sequence: 16:59:28.119 Serial Transmit TID:15 [0]: :GR#:GD#:GA#:GZ#:Gv# 16:59:28.121 Serial wait

I see a HC startup failure at times in the field with no LAN.? The starting sequence displays on the HC starts, waits, switches to connecting to Gemini pauses and then fails to connect.? The screen

That would be a question for Rene :) Not sure why it's not working as in G1.

That’s what I am complaining about – on the G1 you could accelerate from G to C to S David Sent: 25 October 2024 18:04 To: [email protected] Subject: Re: [Gemini-II_io] Allow speeding up

I tried with the other G2 – that was the last log of the set you received in the zip file The BT serial adapter works perfectly with my G1, and the cable tests clean for continuity ? D. Sent: 25

The tactile buttons always work for me (you must be on the screen with diamond buttons on the touch screen). They also allow acceleration to the next higher speed, but not beyond. I can't accelerate

Hmm. I didn't have that issue after the restart. I'll try a few more times to see if there's some sequence that leads to this state. Anything in particular that you do before you try to use the

Looks like it's working... but not every time. Something's wrong with the connection, serial converter, or the serial port.

Here’s the Diagnostics which seem (to me) to suggest the coms is sort of working but (for example): 16:57:14.953 Serial wait for response TID:11 [0]: :GA 16:57:14.964 Serial received: TID:11 [0]:

I haven't tried to use the serial port on the G2 I have so it's possible that it's broken as the G2 wasn't new when Tanya sent it to me for developing the Servo firmware. Here's what I had with my G1

Yes, I did restart – several times in fact as I’m trying to get serial coms working (but that’s for another thread). Sent: 25 October 2024 15:28 To: [email protected] Subject: Re:

The 6.05 and 1.63c betas seem to work fine using normal hand control operations for visual and with ASIAIR Plus v3. -- Chip Louie Chief Daydreamer Imagination Hardware Astrospheric - South Pasadena,