开云体育

I can’t retry as I sent the updated G2 back to the owner. I will update to the latest. Sent: 04 March 2025 01:19 To: [email protected] Subject: Re: [Gemini-II_io] Problem with GFU Not sure why GFU

David, We have been over this several times before.? GFU works fine and very reliability does what it's supposed to do. I just used the current 1.32 GFU and reinstalled L6.1 and HC 1.63 no problem.?

Not sure why GFU 1.0.0.31 would be any different, but I just used GFU v1.0.0.32 ( https://gemini-2.com/GFU-download.html ) and was able to flash HC just fine. Gemini showed "Uploading new Firmware..."

This was GFU 1.0.0.31 if that should be relevant Sent: 04 March 2025 00:54 To: [email protected] Subject: Re: [Gemini-II_io] Problem with GFU Yes, I did have that selected Sent: 03 March 2025 18:35

Yes, I did have that selected Sent: 03 March 2025 18:35 To: [email protected] Subject: Re: [Gemini-II_io] Problem with GFU

Thank you all - I just ordered a replacement screen for $150. Hopefully it's an easy install! Dale

Normally if you have the right boxes checked the HC is enabled to be downloaded but cannot be updated until you reboot the Gemini 2 by powering off then powering back up.? You get a updating HC

David, did you have Flash Firmware selected? HC firmware will not be uploaded if you check just the HC option but not the flash firmware.

I selected 6.1 and asked it to update everything including the HC. HC wasn't updated. I needed to copy the gemhc.bin for 1.63 to the HCFirmwre directory on the SD car using Filezilla and then reboot

Yeah, it sounds like something else is going on. I've not been able to reproduce this, but others have. Something that Rene may need to look into. Regards, -Paul

The servo imposed limit is written so you should always be able to back out of the limit. // // If the position counter is outside the valid range only allow steps // that will move out of the

I was having issues with Nina slewing to the target after plate solving. Giving declination not reachable even though I was less than a half degree from the target. Tried updating drivers, ?ascom

Losmandy has replacement screens ? ? ?Also repairers cheers -- Brendan

I think your best bet is Losmandy directly or one of the repairers in these forums. If you are in the US Michael Herman is your guy, in the UK or Europe, David Partridge is your bloke, in Australia

On Sat, Mar 1, 2025 at 07:11 PM, YAMADA masami wrote: > > Hi, > > I have two Gemini-2 units.? One for my CG-11 (OPW+SLW upgraded) and G-11 > (OPW only). > For CG-11's Gemini-2, I've noticed that the

I hope this is not too dumb a suggestion so bear with me. If the mount was guiding when it hit the safety limit then the speed was likely set to guide rate. Trying to move the scope away from the

So sometimes the buttons work at the safety limit and at other times they don’t? Try to pay attention next time what might be different between these scenarios. Maybe we can find a way to reproduce

Yes strange but it only happens to me occasionally (rarely) in these situations. Next time I will get some logs and some supporting docs. Ken

Strange, as I seem to be able to use both, the tactile buttons in the back and the touch-screen buttons in the front to move out of the safety limit. Going past the safety limit works at centering

Hi Paul - thanks and my situations were just during normal imaging sessions with a target that tracked into the mount limits. The HC and virtual HC buttons didn't work similar to what I think David is