开云体育

I use an older version of NINA and if I remember correctly, this was an issue with it. It happens after finishing the three point polar alignment, when I press to stop the routine, the mount stops

Loose coax from Gemini to motor; moves after flip

Not moving.? ?Star trails are very large, not subtle.

You mean it’s not tracking at all; after 20 minutes it hasn’t moved? The mount should clock along, then receive your guiding correction in pulses. Not moving, or not autoguiding the moving?

The physical buttons are, you can also use the touch screen for one axis? and a physical button for the other. But the physical buttons you can also push both axis simultaneously.

I've been having problems with the mount (GM811G) stopping tracking (or not starting?) after a slew or plate solve.? ?This has happened many times (seen it in 30 imaging sessions?).? ? Problems

Ryan, the touch screen is not multi-touch, so press only one button at a time.

This may need to be a different thread, but something else that has been happening at L5 and L6 even with updating the firmware. When i click the DEC or RA button on the touch screen OR the bottom

I did have the problem before and turned off the NINA to mount sync which helped. I ran it last night with 0 problems. Guiding RMS was 0.3 total, performed the meridian flip perfectly. So Hopefully

Ryan, When first starting out with my GM811G HD I did quite a few "Factory Resets" To make sure I had not screwed up one of the settings. It takes you back to reset anything we, as humans, may have

If your time zone changed then you might want to look for other settings that changed.? Verify the new time and SAVE it.? Power down wait 20 seconds and.thwn reboot Gemini 2 and verify your time is

Gary, It sounds like you don’t have FireCapture set up correctly for your mount… Sometimes I’ll do the same thing as JB. Other times I’ll build a small 3-4 point model on whatever side of the

Thanks Art. I did use SharpCap a couple years ago. I will go back and try it again. Gary

Thanks Rene, Paul Rene - thanks for the detailed information. After the PDEC error I changed the battery/reset & reconfigured the Gemini-2 then did a cold start etc so I think it would cover your

Although I have used Firecapture for years, and think it's a great piece of software, I have recently switched to Sharpcap with outstanding results. The image quality is noticeably better, and you can

Hi Gary, My customary way to proceed with my own G11 for occultations by asteroids (and likely working for planets) is to centre the target and run the guiding with NINA, then disconnecting the camera

Been using my G11/C11 setup for DSO with NINA for a couple years. A few months ago I changed com from USB to Ethernet to connect to the G11. Works great. Now I'm doing planetary with FireCapture. As

Hi Ken, The PRA and PDEC values show the Physical Step counting in the respective axes. Their upper limit is the amount of steps for a complete circle. You can watch these values changing in the

Hi Ken, that really does sound like an issue with intermittent power. Whether it's the supply, the cable, the connector or some other issue inside of Gemini is hard to tell from here. Regards. -Paul

Thanks Michael - I replaced the power supply with a new one a few days ago. I will double check its' connection. Ken