开云体育

I have a substantial 10” Newt on my G11G and the 12” pier extension allows me to image up to 55 minutes past the meridian. That being said, an 8” would have worked as well. I also have the RA

Hello, I am not sure if this is the correct forum but I will ask anyway.? I have a G11, non-tucked in motors, Gemini 2 recently upgraded.? When I use the G11 with a short refractor I can set the

On Sun, Nov 3, 2024 at 12:47 PM, <kevinwalsh324@...> wrote: > > I got my new G11 this past Spring and I went through the various YT > videos. > > > I used this video done by Scott to build a

Chip That was Pauls reply. The mac is the same for all mounts and you have to go into the web server and alter one of the two mount mac addresses. I found I could get around Gemini telescope not

That's exactly right. All Gemini ship with the same MAC address. To use them on the same network, at least one of the two must be changed manually.

Oh, I forgot.to mention that I have had three Gemini 2 controllers on my home LAN and the all worked fine but all had different IP and MAC addresses.? I never tested operating more than 2 at once as

Hi Chuck, The Gemini 2 controllers all come from the factory with the same MAC address by default.? It's easy to change the MAC address and this should allow both to work without mistaking one Gemini

Chip According to paul, if you have two losmandy mounts on the same network , you can get the same mac address. You have to go into the web server and manually change one of the two mac addresses. I

Thanks Paul, I will try that and report back!

On Mon, Nov 4, 2024 at 06:59 PM, Paul Romero wrote: > > Hi there, > > I have the Gemini 2 with L6. The ASCOM driver, CPU, and HC firmware are > the latest betas. ?One thing I really like about the

I understand, Tony, but I am not there to observe in person what you're doing and what the result is, so I have to ask questions if anything is not clear to me. And I usually ask them starting from

Hi there, I have the Gemini 2 with L6. The ASCOM driver, CPU, and HC firmware are the latest betas. ?One thing I really like about the park mode that requires a go-to command to park the mount is

Thanks for the reply but all was set correctly. This is not a setup problem.

Paul, I think you are missing my point. I always do a cold start and always check date and time and time zone but none of this would cause the issue I have. I stated in the original issue that I could

Tony, the change from DST seems too much of a coincidence, especially since you say everything was working fine previously, and something had to change. Double-check th

Tony, It “sounds” like you may not have adjusted the correct time on Gemini 2. As Daylight Savings ended yesterday, it would be smart to check your time and correct Gemini 2 if needed. The

Paul, Thanks for the reply. I can try your suggestion using Synchronize but I think something else is going on here. Also, whenever I use this mount I use GPS for location and time and adjust for the

On Sun, Nov 3, 2024 at 06:15 PM, <tony.kiefer@...> wrote: > > Last night, at one of our astronomy clubs out reach programs, I couldn't > get the modeling program to work on my G11 mount Gemini 2.

Last night, at one of our astronomy clubs out reach programs, I couldn't get the modeling program to work on my G11 mount Gemini 2. I tried using align and the model program that shows at cold

I got my new G11 this past Spring and I went through the various YT videos. I used this video done by Scott to build a model and set the polar alignment. (I can only see Polaris seasonally through