开云体育

Hi Mike what instructions did you follow? The details depend on how you are connecting: if you are doing a direct ethernet connection there's a tutorial here: https://youtu.be/b4J5tQxvH9E if you are

Hi I used the ethernet connection from my old Dell Win10 machine with no problem. I followed theGemini II setup instructions and it worked great. I now have a new Lenovo Win 11 laptop and I cannot get

The ASIAIR / Gemini-2 combination works great! I have used USB to connect the two no problem. That said you need to used the correct USB ports on both for best results. On the Gemini-2 you must use

Hi George, Gemini.NET doesn't automatically re-read the changed parameters unless it knows that it needs to do so. If you update the model through Gemini.NET, it'll automatically update these by

I've just set up a new observatory with a new-to-me, never used Losmandy G11G wiith Gemini 2. My goal is to control the G11 with Starry Night or Cartes du Ciel (I like both well enough). My first

A couple more fixes. Konstantin Baranov fixed the tracking rate selections. It looks like they've been broken for a long time. I fixed the "tracking ON / OFF" status in ekos. It looks like those were

I agree with Zolt - whenever my ASIAir fails to recognize/connect to my G11G, it is always due to the cable. Either the connection is poor at the ASIAir end (loose), or the USB-B (printer) cable

Hi Bob make sure you are using the correct USB port on the Gemini 2 https://youtu.be/_OjFoA0Cq54?t=80 -- Brian Brian Valente astro portfolio https://www.brianvalentephotography.com/astrophotography/

Maybe check that the cable is good? Do you see Losmandy Gemini as one of the choices in the Mount menu? My Air connects to the mount OK, though sometimes the USB connection is loose on the Air.

Hi Bob, Do I understand that you can see your imaging and guide cameras already on the app? Gemini's should be really easy as they remember time location etc.

I recently bought an ASI Air to connect mount, telescope, camera, and guide scope.? I tried connecting the ASI Air using a USB cable that fit in the port on the Gemini.? When I try to access the

Hi, I remade all soldering of din plug on the mainboard and verify visually all the others. looks good. After that mounts works well for 10mn. Then I had again both messages back from powerfail DEC

Correct. In G2, bit 2 Modelling in use is used to indicate whether an alignment was done. Bit 1 is always set to 1.

ok

FYI this is confirmed as expected behavior. Gemini 2 has no "Initial Alignment" anymore, <99 always returns 1 + x. The coordinates are taken from startup. -- Brian

Frank I'm going to set you up with a support ticket so we can talk directly There's a lot of cooks in the kitchen right now, and I realize it can be confusing for all wrote: -- Brian Brian Valente

----------------------- Jim W Phoenix, AZ USA

On ----------------------- Jim W Phoenix, AZ USA

In the auto meridian flip settings, is the "use telescope side of pier" on or off?

I haven’t looked though each of the previous posts so I am likely missing necessary information. I am running 5.21 and I think ASCOM Gemini Driver 1.1.17.0 with NINA 2.1 HF1 RC0x and haven't had