开云体育

cables are fine as well

I have done all those things. the RA and Dec cables are correct, I always start from CWD, Safety limits are exactly where I left them last. I have not done a factoury reset, but to be honest I ran a

So you plugged in RA motor into DEC socket, using DEC cable, and it worked fine in both directions? This would point to a problem

Hi Paul, Yes it is definitely a Dec issue with the latest results. I changed the Dec cable as I was finding that Dec movements in one direction were hit and miss but the other Dec direction was fine.

Sounds like you may want to: * Start in CWD position with Cold Start * Check that RA and DEC cables are not swapped * Check that your safety limits have not moved * Check that your RA and DEC cables

Similar - to a degree --- I noticed that NINA Flat Wizard tool - the slew to zenith always goes to the same side whether E or W side is selected. I also have noticed Three Point Polar Alignment tool

For what it’s worth I am in the same boat with Kstars and Indi as the controller. For now my solution has been to turn on Gemini with the hand controller plugged in, be sure to select Cold Start and

I am at a complete loss. I will boot up my gemini II. connect to my pc with the gemini ascom driver, and try to slew to a target to image. Rather than slewing to the correct part of the sky (scope

Jean-Bernard, Have you tried a different USB cable? Paul

Hi Paul Unsure how to tell which Gemini driver I had loaded. However, based conceptually on your recommendations, I installed ASCOM 7 and simultaneously rolled back my Gemini driver from v1.1.28 to

Hi Ken, that sounds like a possible issue with DEC cable or connection. The error is coming from Gemini itself, and is produced by an internal check for consistency of the DEC motor encoder counter

Hi, Last night I was trying to park the mount and I kept getting "PDEC out of range" errors popping up from the ASCOM Gemini driver. The mount wouldn't park so I turned it off and will level it today.

Good evening Paul, I have been using the configuration for years: G11T mount – Prism v11 acquisition software – ascom platform – ascom gemini driver – Windows 11. For 15 days, for an unknown

Sounds like a timeout when communicating with Gemini over the serial port. What are you trying to do, and what changes to your configuration may have caused it? Regards, -Paul

Hello, What does the message below mean please? I can't point any more targets. Thank you. Best regards. Jean-Bernard Pioppa

Hi Conrad? You may be using the wrong ASCOM interface. There are two available, and you should only be using the one without number '2' in the name. The second one is for those who have two Gemini

I have a puzzling workaround regarding a USB connection problem from a PC to Gemini 2 Mini controller. I would like to eliminate the need for the workaround. The problem is that for my “on mount

On Fri, Jan 10, 2025 at 02:50 PM, Paul Kanevsky wrote: > > On Fri, Jan 10, 2025 at 12:05 PM, david hill wrote: > >> Paul, >> Would be nice to know how the problem was resolved. Might be helpful to >>

Hi David, as Tony said, the main trick was to add the Ethernet service to the Macbook configuration. Since the laptop didn't have an ethernet port of its own and Tony used an external adapter, there

David, Two issues that were resolved (with the help of the group). The first was that I had to create a service in my Mac Network folder for the Ethernet connection, which for some may be