开云体育

Great to know! thanks for the clarification.

Hi Ryan, yes, the automatic drift correction is applied when PEC programming is completed. But unless you see noticeable, uncorrected drift after PEC, I would not recommend that you reprogram it. The

Paul If I understand correctly, does that mean an existing PEC will therefore not be affected by the change/update? Would it be beneficial to record a new PEC with PEMPRO again? or is it only affect

Hi Tom, You will likely find that to get maximum limit range you will need to do all of the actual mount updates starting

Great tip, Ken.? Just now ordered some DeoxIT.

Worked like charm, Paul.? This is a testimony to the robustness of the Gemini as I had purchased my GM811 almost 3 years ago and never had a glitch.? Thanks much.

Recalibration did the trick for me last week. I had a similar issue except it exhibited itself by cycling through language options as I touched Cold Start over and over. The Groups archive quickly set

I'm running a 2020 G11G with a C11 and as equipped there is 43 pounds of counterweight. Since it's balanced I'm assuming the equipment load is the same, plus or minus a couple pounds. This is about

Going out to recalibrate now.? Thanks, Paul.

Hi Ken, there is an automatic drift removal that Gemini firmware performs when PEC is trained. That’s been improved, as well as, additional serial commands added to adjust for clock drift, if it’s

I suggest you try to recalibrate your touch screen: https://gemini-2.com/quickstart/screenalign-1.html

When these happen I generally take the cable out and spray some DeoxIT on the RJ8s and then seat/reseat/reseat the plugs at each end and then try again. If I also notice that cable may have been

After powering up the Gem2 controller (V 5.21) last night, I had minimal response from the touch screen on the HC.? Didn't matter if I used a Cold Start or a Warm Start.? If I selected Quick Start,

Thanks Paul - can you also provide more information on how to utilize the last item "MU: Enhancements for PEC precision, drift removal" Ken

Just ordered the factory upgrade service, looks like my timing was good. Thanks, Paul and team.

Thanks Paul and devgroup team! -- Chip Louie Chief Daydreamer Imagination Hardware Astrospheric - South Pasadena, CA Astrospheric Signature (

Great news Paul.? Thanks for the update. ----------------------- Jim W Phoenix, AZ USA

Hi Folks, An official new version of Gemini firmware Level 6.1 and Hand Controller firmware v1.63 are now available for your Gemini. A few ways to update to this version: 1. Use GFU app (

I agree.? For folks using NINA the Three Star PA P

Hey Tom, Yes, I do, thanks for asking: https://www.astrobin.com/users/noon/ I've pretty much completely rebuilt the scope from scratch which made it much more usable... most of my more recent images