The issue of PA will slow/motion rotation to 60degs is easier then that. Soon as rotation should begin, look as the speed selection in lower left of HC. Simple toggle to ¡°slew¡±. ?Always it goes. ?This takes little effect w/o screwing wick the mounts speed settings.
I don¡¯t have problems with flips that I recall. ?Other than not letting AAP re-plate solve after the flip. ?
toggle quoted message
Show quoted text
On Nov 18, 2024, at 5:11?PM, Tjkallenbach via groups.io <Tjkallenbach@...> wrote:
?
My experience is that while I still experience "problems", most of them have work-arounds.? For example, when I run the polar align routine in the air, the degrees of rotation will not count up.? Even though the mount is moving the counter stays at 0.0 degrees.? I have to cancel the operation and run it again for the degrees to increment toward 60¡ã.? If I just let it go without the count, the polar align fails and I need to go to CWD with the hand controller, switch the air off, switch the gemini off, restart the gemini then restart the air.? It is not a big deal just a little quirky.? After a successful PA, I go home and restart everything.? Oh...going home, When I tell the mount to go home in the air, the mount will go home but I do not get the message go home success or whatever it is.
When it is time to do a meridian flip it seems that the mount will not move until the air has issued the command three times but then will do the flip.??
?
Tom
?
?
