Hallo everybody,
Finally, after the advices of Russell Jancinc from Losmandy I could solve the problem on the Gemini 2 Main Board which was bad flashed for a partner and it caused a serious problem of comunication with the unit. Russell adviced me to do a telnet connection with the main board using a? DB9-RJ12 cable that I built for this. I have used the HyperTerminal included with Windows to connect with the Gemini, previosly I had done a new Micro SD card with including the lastest NewGem.bin file and folders as is exposed on the files section of the group and following the instructions and help from Tom Hilton. I have also put the lastes HC firmware bin file on the HC Firmware folder on this Micro SD as Tom adviced me.
To can start the connection with the Gemini by
Hyperterminal is necessary to have the classic hand controller of Losmany, fortune, I had one!, if not it is possible to do an RJ12 adapter. After stablished connection I could reprogram the unit using the NewGem.bin and a PROG command on hyperterminal. After this I power off the unit, plugged the Gemini II Hand Control and power on... yes, it works! and the lastest HC Firmware is updating on the HC.. now all is ready to work. This new board and HC looks very very good..
I have to thank to all the people who has helped me and supported me with this matter, I have learned a lot, the problems usually are a good oprtunity to learn, it?s not too funny but you can learn a lot.... Special thanks to Tom Hilton and Russell Jancinc...
Ok, I hope I can offer a little help to anyone !!
I have now some questions about some tips on the Gemini II, but I will ask in another post.
Thank you very much!
Miguel Angel P¨¦rez Hern¨¢ndez
Alpha Cygni S.L.
c/ San Agust¨ªn, 23
38410 - Los Realejos
S.C. de Tenerife
Islas Canarias - Espa?a
Tlf/fax: 0034 922 34 30 38
?
?nete a Betacygni, la trastienda: ?
