Re: GEO 210 Probe budget kit

Michael C All Messages By This Member #16 开云体育 Up and running.? I ended up putting the resistor at the BNC connector and shrink wrapping the crud out of that end for strain relief purposes. Then I pigtail loop under and around to the LND terminal with other end of wire soldered to the clip.? It’s a tight squeeze.?? This little thing kicks butt ??? ? toggle quoted message Show quoted text From: [email protected] <[email protected]> On Behalf Of GEOelectronics@... Sent: Friday, May 15, 2020 5:27 PM To: [email protected] Subject: Re: [GEOelectronics] GEO 210 Probe budget kit ? 1 resistor. The other is spare, both same 3.3 Meg Ohms. ? Goes in series with center pin from BNC to the clip. Ludlum solders the resistor right to the clip, then the wire to the other end of the resistor, so I do it that way. ? George? ? ? ----- Original Message ----- From: Michael C <mtcooper01@...> To: [email protected] Sent: Fri, 15 May 2020 18:58:27 -0400 (EDT) Subject: Re: [GEOelectronics] GEO 210 Probe budget kit ? sorry if you have already answered this..? the GEO 210 probe kit included two resistors.? Not sure the value, they appear the same.? a) I assume I only need one of them. b) where does the one resistor go??? Is it inline from the BNC connector center pin with the red wire to the LND clip??? thanks ? ? ? ?

Join [email protected] to automatically receive all group messages.

开云体育