1 resistor. The other is spare, both same 3.3 Meg Ohms.
Goes in series with center pin from BNC to the clip. Ludlum solders the resistor right to the clip, then the wire to the other end of the resistor, so I do it that way.
George?
----- Original Message -----
From: Michael C <mtcooper01@...>
To:
[email protected]Sent: Fri, 15 May 2020 18:58:27 -0400 (EDT)
Subject: Re: [GEOelectronics] GEO 210 Probe budget kit
sorry if you have already answered this..? the GEO 210 probe kit included two resistors.? Not sure the value, they appear the same.?
a) I assume I only need one of them.
b) where does the one resistor go??? Is it inline from the BNC connector center pin with the red wire to the LND clip???
thanks
