开云体育

So I was able to send using the RTS line when connected through my PC using hamlib and N1MM however I can't get hamlib to work on my Raspberry Pi with fldigi to key the same line.I'm able to directly

Thank you Mike. 73s nd regards Unni [email protected]> wrote:

This could be an indication your frequency synthesizer is out of lock. Download the service manual and troubleshoot. Mike N2MS

I was successful with the K3NG keyer. You can build one with ?Arduino or buy a kit. 73, Alex Here’s the link https://blog.radioartisan.com/arduino-cw-keyer/

Checked that also I am inside Ham bands only VU2TE <michael.newbury@...> wrote:

more than likley your trying to TX out of band mick SA4MDN

DE VU2TE again When th PTT is pressed the display shows TX error. 73s Regards Unni

Dear all Suddenly today my 857D display started flashing. This display was the a replaced one due to zeebra lines an year back. Did all reset but no result. So from where I should start diagonising.

Suddenly today my 857D display started flashing. This display was the rplaced one due to zeebra lines an year back. Dis all reset but no result. S from I should start diagonising. Input voltage is

To send CW via FlDigi you will need to setup the DTR-RTS Keying parameters for CW under the Modems in the configuration. That will be the RTS or DTR line using RigCat serial port. Or you can select a

I don't know how, but I have U5 Link box from AlliBabaand CW is ok with COM4 port, together radio control,using N1MM+...73 DXI / SP9NY Vitor Luis Aidar dos SantosPY2NY, SP9NY, V26NYCaixa Postal

Good afternoon, I have a 857 that I have connected to a Digirig. I would like to send CW using FlDigi. So far I have tried to send it with the radio using sideband and I'm seeing no output power which

I have 2 of the yeasu mh-48 mics if you would like to borrow one to test. They are brand new in box waiting to replace 1 of mine when they inevitably go bad at some point. Justin R Poole Networking

Yes with the RJ45 plug I have the center conductor on the headset mic plug is to pin 4 blue/white and bare wire to pin 5 solid blue. PTT is wired into a foot switch, I have PTT control but power on

Did you wire the Mic to pins 4&5 of the RJ45 Connector. How are you providing ptt to the radio?? Are you using VOX mode and if so did you try adjusting Menu 88 vox gain? Also do you have menu 59

The SB40 is a dynamic microphone so it doesn't need to be powered. I cut the plug off the microphone end and found a single insulated white wire and a bare copper wire. I'm assuming these are signal

I have purchased this switch:? Antenna Sharer, SDR Transceiver... https://www.amazon.com/dp/B08L4YSVJG?ref=ppx_pop_mob_ap_share It is powered by 12v and uses a ground signal to close the relays and

Hi Vitor, I don't know N1MM+, but supposing you want to type on the keyboard of the computer and send CW (probably with another app), usually the best option is to use an interface that does include a

Thanks a lot Anne Let's separate a little keyer to the baggage and finish thisnovel hi hi hi... I have CAT control, computer, original FT857 microphone,antenna, antenna tuner. That's will be

HERE is Google AI answer . Cool, it even highlighted the "short version ". For CAT (Computer Aided Transceiver) and CW (Continuous Wave) connections with the Yaesu FT-857D, you'll typically use the