开云体育

Hi Rafael, Also, zero interest here. My contention is that they put too much lateral strain n the shaft of the encoder reducing its life. 73….Eric VK2VE. Sent: Monday, 16 September 2024

I would like to have one...

I'm interested...keep me posted on this Please

Zero interest here, Rafael. That's about the last thing I'd ever want on mine. But good luck in your search. 73, Kent K9ZTV

How about a spinner / crank knob?? ?There was only one person making them in the past but no longer. -- Rafael / NN3RP

I had the same thing happen to mine in the car. Replaced the modular cable from the head to body and it has worked fine since... (didnt have the crimp tool to redo the ends...) 73 and good luck Art

I had a similar issue in my mobile installation, even tried installing my second FT-857d in the vehicle, thought it may have been a power issue, finally tracked it down to a faulty crimp on the

Hi all, I have a an 857d that has been exhibiting a couple of strange symptoms. First it seems that perhaps some relay keeps getting stuck, as after some amount of normal operation (primarily cw or

...in the car ?? did you verify the raw voltage ? battery itself ... car running --- charge voltage ? I think the manual has "power supply range 12V +- ?? your issue sound like low supply or

Dear Ed. Did you check the original DC connector plug? I had some problems every now and then. I removed it and wired a Power Pole connector. After that I did not have a problem of Power

No Eric. Completely dead! Yahoo Mail: Search, organise, conquer

Hi Edward, Does the power relay briefly click on and straight back off again, because that’s what mine is doing? It’s on the bench at the moment but I haven’t had time to get back to

I had the same thing happen to two of my ft radios. Connecting and disconnecting a battery charger or battery maintainer can create an arc necessary to short out the surge suppressor that is across

Hi All, I found this 3d printable file for a custom remote head mount in 2019-Current RAV4s and am planning to modify it for an 857. Is there anyone else out there interested in having one printed

I am using it mobile and vehicle was in the garage only. No antenna attached when this happened.? Thanks? Yahoo Mail: Search, organise, conquer

Hi..same thing happened to me, after a power surge from a nearby lighting strike...fried the 857, the laptop and display and the Digimode interface....as well as a couple indoor floods and one garage

Just in case it is helpful the FT-857D has undocumented Cat control access through the microphone port. There are after market and home brew adapters that make using it more convenient by avoiding any

Edward, Time to locate your schematic diagram. Find the point where power entres the radio, search for a fuse, it will most likely be noted as a 0 (zero) ohm resistor. Now you need to consider WHY

Hi, All of the sudden my ft857d won't power on.? I already checked. Front Panel is OK. Voltage is OK as well going into the board inside. Any idea what went wrong?? Thanks, Edward?4F1OZ Yahoo

Thanks. I might just use it with the audio going between the radio and phone using the speakers and mics. I thought there might be an easy single cable way but seems not. -- Compton VK2HRX Sydney,