开云体育

73 art N2AJO

Kent, Well that's an entire other issue which I think I understand now but at the time I was grasping. This all started with my rig having no TX on 14/10? MHz.? ?I've had a similar issue with my

Troy ... Thanks for the additional info. You're right, another reset may restore the RMT option (along with others that might be missing). Be sure you and the rig are at the same potential -- touch

As a follow up..... I've had this mic working on this radio with no issues.? I needed to do a factory reset and after I did I needed to set the radio back up again.? that is when I noticed I could

Are you first getting the "extended menu" ? Reference the steps in the mic manual ..

Hello group, Has anyone tried our radio with the Heil HC-74 microphone for DX? Any reports? Thanks 73 Stefano (IU?DFT)

Typo ... RMT appears in menu 59 of my FT-857D whether a microphone is connected or not. 73, Kent K9ZTV

REM appears in menu 59 of my FT-857D whether a microphone is connected or not. 73, Kent K9ZTV

Are you setting menu 59 while the MH-36 is connected? According to the manual Before connecting the MH-59 A8J , you must instruct the FT-857’s microprocessor that the MH-59 A8J is being used.

Hi, The older FT-857 supports the MH-59a8j microphone.? FYI:? The remote microphone was released at the same time as the original FT-857. If the FT-857 doesn't show the RMT option under Menu 59 it

If RMT does not appear in menu 59 between NOR and CAT, I suspect it means you have an early FT-857 and not the later FT-857D. 73, Kent K9ZTV

I am trying to add the mh 59 mic. Selecting menu 59 I see only NOR and CAT? ? RMT is not an option this is second attempt to post sorry for the dup if first posted

I have a MH 59 a8j? Mic.? ? When I select menu 59? I am presented with only NOR or? CAT as I rotate the knob.? ?RMT is not an option.? ?The mic is plugged in.? ?Any ideas what I've done

Thanks for the quick reply, everyone. This very helpful. I will follow up with suggestions. - George

I sent mine to Yaesu in California recently. I received an e-mail that it is in the queue for repair. How long they will take, I don't know. 73, Zack W9SZ [email protected]> wrote: [image: width=]

I have had a couple of 857’s worked on by this guy. Send him an email and see what he can do. Andy Ruggiero WD8BWW andyit28@... 73, George W8CFI

I've had good service from HamradioRepair.com. Ronald Jakubowski K2RJ

I had a guy Byron Campbell WA4GEG repair a Yaesu for me some years ago. He says he does not do the 857. He did list others on his page who work on different model Yaesu's.? He gave the name Andy

A few years ago I tried to add a module to the receive section of the FT-857 in order to connect to a computer for a waterfall/panadpter, but I damaged a couple of the SMT resistors. The radio

OK.. Update... After conferencing with a friend I figured out that the CAT connection that the YT-100 tuner uses is different than the 6 pin connector the SignaLink uses.? Got it all connected last