开云体育

JD: Thanks for taking the time to send the parts list. Will give Yaesu a call tomorrow. It looks like these are not manufactured by TOKO so they shouldn't have the same issues. Tony

Relatively easy to replace. You need enough heat to heat the ground plane enough to desolder. Be careful not to knock off the nearby parts. The board will have to be removed, but it is not a difficult

Order then from Yaesu. They are very inexpensive at less than a dollar each. H3900587 CERAMIC FILTER LTM455EW-A $0.71EA 5 IN STOCK H3900589 CERAMIC FILTER LTM455GW-A $0.71EA 5 IN STOCK H3900588

All: Need to replace the TOKA ceramic IF filters on my rig and was wondering if anyone knows where I might find a distributor in the U.S. Noticed a few overseas sources on eBay but would rather go

Released the new version *1.1.0* of CatRadio. Major updates: AF Gain and Squelch slider Tab with CW and FM functions CW keyer speed FM repeater shift and CTCSS tone Red color VFO during transmit SWR

It is a shame it cannot use QT5 to be compatible with Debian 11 even, and slighter older and other linux distros. Is the source code available to compile, rather than binaries ? vk4tux

CatRadio is the new multiplatform free software to control rig via PC. It uses the Hamlib libraries and supports many models and functions. Please download here

Hi Bruce. When you say you measured the voltage at the connector, can you clarify which connector? I also assume the radio is working perfectly otherwise and when you select TUNE on the menu the

I will try it when the weather warms up. It is about 18 F outside now. wd9ghk

VSWR Adjustment 1. Connect a 100-Ohm dummy load to the HF/50 MHz antenna jack. 2. Tune the transceiver to the 14 MHz band in the CW mode, and set the output power to 10 Watts. 3. Select menu item

Robert, I have used the radio with two of the ATAS antennas in the past. This started about a year ago. I measured the voltage at the connector on the radio. I have tried the antennas with a power

I did not know advertizing is allowed here? Can we all stuff the list with our advertisements? I could sent ton of stuff on daily basis. -- 73 de Pedja YT9TP

Hello Gang, Here are my new Acrylic Call Sign Displays, with Dual LED Zones and FT8X7 Bluetooth interfaces. Drop-in to WWW.VE2DX.COM or contact me at ve2dx@... if interested. 73 Richard VE2DX

Be aware that likely the cinese cheap tcxo unita? are NOT crystals but they have a PLL inside. They should be charachterised for spurii and phase noise, this should have a consequence at least

Where are you measuring this voltage? Depends which way you are driving the antenna, Voltages the radio applies to the ATAS antenna are 8.36 volts to move down, and 9.76 volts to move up. There is an

Yes, I said low voltage. In order to use the ATAS antenna the rig should put out 8 volts. Mine only puts out 4 volts. Any ideas? wd9ghk

Steve A typical Chinese TCXO must be removed from radio to access adjustment tap - a really useful feature (NOT), while the real McCoy can be adjusted in place.? Regards, Phil / K4PO

I bought all these from HRO, I'll try them instead 73 Steve

I'm sure Radioworld can help you. John VE7KKQ wrote: