开云体育

Will Do. -Pat

As a Ham radio operator I do send cards to the SYL or family of Silent keys. I am looking for New Pomes; I have two but am widening my scope. If you find any or wright one please send them to:

The pin diodes are a very common fault. Many people can change them and do other work on these popular radios if you cant. You dont say where you are so a bit hard to answer you. -- Compton VK2HRX

Check for leaking capacity.? On Fri, Aug 20, 2021 at 11:16 PM, Mark Springer<wl7bct@...> wrote: My 857D sounds like it needs some front end work, no sensitivity on V/U. Any suggestions of who

No, I guess I can! Tx es 73

Hi Mark, Have you tried a full reset? 73….Eric VK2VE. Sent: Saturday, 21 August 2021 13:16 To: [email protected] Subject: [FT-857] 857D Tune-up My 857D sounds like it needs some front end work, no

My 857D sounds like it needs some front end work, no sensitivity on V/U. Any suggestions of who works on them besides Yaesu? Thanks de Mark WL7BCT

Recently I got a FURUNO PA2500 linear.? all the modifications of the band Switch is done. For 12 Volts I used a DC-Dc Buck converter which I could accomadate inside itself.? My present problem is

Hai all I got a FURUNO PA 2500 recently and modified for ham band usage. But a full CW break in cannot be achieved. Will using a 7812 regulator? connected to 24V line and use the 12 V for control is

I had this problem in my shack and added a 1:1 current balun in my coax and it cleared up the problem. 73, --Hank KB4MTO /TA5ZC Sent: Saturday, July 31, 2021 10:18 AM To: [email protected] Subject: Re:

I did finally remove it from the truck and look inside. Nothing obvious. Next step hook it up on the bench. Just need to find the short cable to hook up the front panel. ??? Randy

Did you find a solution to this problem?

Hi Dwight, Can you post the link to the YouTube channel you watched about the EEPROM memory chip? Israel

Israel, here is a post I did a while back... possibly you are having similar problem... Hey group, Thought I'd share my experience fixing my 857. (Probably 15 years old, always used inside) In the

RF in the shack, often in the forn of CMC (common mode current on the braid of your coax) is definitely on the list as a "can cause this". CPU lockup, etc this is one good reason to check using a

Israel,? Like john suggested, it could be RFI. Chokes are always a good idea on power leads. It might also be power Check the connections and fuses for corrosion. Also try another power supply and

Sounds like RFI on the power leads, put some chokes on the power leads. Not aware of any batteries in the rig, mine is over ten years old, no indication of a battery. John VE7KKQ [email protected]>

My 857d reboots or locks and has to be completely removed from power to reset. Friend mentioned internal battery may be bad. Anyone know where it is? (I can't find it.) Thanks! Israel

HI Tim, Here is a link to a site with some info on building an FT-Meter equivalent. Very simple. I made one almost 20 years ago with great results. https://www.basic4mcu.com/bbs/board.php?bo_table=k10

Glad you got it working --- But one of the other questions is "Why are you getting enough RFI in your shack to be able to cause problems with electronics" RFI in the shack is a problem itself -- not