开云体育

Thanks Tony. Will check into it. 73s GL Unni FT-857@...> wrote:

Or else go to the channel mode. Channels with the names M-601 -> M-605 are the legal way to transmit on 60 meters.

Sent from Mail for Windows 10 Sent: Wednesday, February 20, 2019 8:25 PM To: FT-857@... Subject: [FT-857] 60 mtr transmit FT857D ? You will need to unlock the TX of the FT857 by

Any procedure to activate 60 Mtr Transmit in FT857D. at home level. Rx side no problem VU2TE Unni

Disregard! Menu 17 adjustment (and saved) fixed that

Supply Voltage reads 16.3v on the LCD. My supply voltage is 13.9 (I measured with two different DVMs). Performed full reset - made no difference. Any thoughts? thx and 73 Alan, W4FBI

I compared the pcb with the filter mod, and that somebody previously had attempted the mod, cut traces, 1 cap in place, not the 2nd, nor the resistor.. The really strange part to me was that the pads

Try the WolphiLink: http://www.wolphi.com/interface/ Also available are DroidRTTY and DroidPSK apps for Android. Travis, K5HTB

Thanks Phil. That is what I needed to know. Mike / W8DN

That small cap is likely a user inserted DC blocking cap that is recommended for the 857 filters that have a history of being destroyed by DC to filter. This is a Yaesu design fault. Many 857s have

Mike, Heil normally color codes their microphone to rig connectors as Yellow = Yaesu, Blue = ICOM, & Red = Kenwood for the popular rigs. Hope that info helps. Phil / K4PO

I replaced the 3 filters this evening, one of the filters had a small cap and a jumper wire, needless to say I did not take photos before I started on the bottom side of the board. I'm hoping somebody

...now that I think about it, this headset can't be for the 857 since the 857 uses an RJ connector. Duh !! Must be for my TS-850S/AT or my Flex 5K. Kinda nervous about just plugging it in for fear of

Greetings All, ? I have what I "believe" is a Heil single earpiece, boom mic headset for the 857 but am not sure. Description is: Single earpiece with oval (not round) cushion Red stripe on headpiece

Hi Brad: Yes I have done that with no success. 73 De Mike VE3YF

Hi Handford: I played with the 3 menu settings that I mentioned and no change. I am going to wait till warmer weather is upon us as right now around -20 F and even colder with the wind chill. My next

did you hold the tune button in for 2 secs to initiate tune?

Hi Mike I have the same setup as you but I have a Little TARHEEL ll I leave the radio in SSB and then when you push the tune button the turbo tuner keys the radio and the ant will tune to the

Hi: Just finished installing the FT-857D with a Turbo Tuner 2 and a Tarheel M200A-HP antenna in my 2018 Nissan Rogue. I have run into a problem that I have hopefully narrowed it down to the FT-857D as

If you are planning on running RTTY on FM then the rig will have to be in FM mode (not digital). Should be no problem running RTTY tones there. Just set up like you would to run FM voice on VHF. You