开云体育

When using menu 75 to set the output power level, I've noticed some odd results When it is set to 5W, I see miliwatt power on 2 different meters (LDG FT & SureCom 102 HF) When I increase this

Back to First Principles - R.T.F.M. I went back to the innards of the Signalink and examined the Connections.? They were good - but not in the right Sockets.? I'm running fine now. I had taken the

I looks very much a lack of audo > modulation causing the issue. One other thing to check is your hardware, and are plugs in deep enough ? Some have a shoulder that prevent deep connection,

Thanks Bill, that Tune feature is handy.? However, when it sends the signal through the Signalink, the PTT light goes on, but it does not send any signal to the Radio.? Nothing shows on the

Thanks Dan,, yes good reminder.? The "Cat Calls go through another cable directly from the Radio to the Computer. ?? So, I tried to append a copy of my Ardop settings to identify a possible error

FYI the signal ink doesn't do cat. It is a sound card with ptt Dan KC2STA <kevin.kc.woods@...> wrote:

Compton, yes my eye was drawn to that feature too. Digital Gain Menu37 has been set at 90 throughout my testing. Also CAT Rate Menu19 is set to 9600. I have appended a copy of my settings for the

Hi, Kevin I run an FT-857 and SignaLink combination very successfuly on Winlink (using Winlink Express), all the FLDigi modes, all the WSJT-X modes, etc. I'm somewhat confused by your statement that

Worked for me. Paul, KD0ETL Sent from Outlook<http://aka.ms/weboutlook> Sent: Sunday, September 22, 2024 5:55 PM To: [email protected] Subject: [FT-857] Signalink Problem with Winlink - Not

What is menu #37, DIG Gain set at? -- Compton VK2HRX Sydney, Australia

Thank you Adrian. Yes, it is set to Digital and User-U. [email protected]> wrote:

Is the radio in 'DIG' mode during this ? 73 vk4tux

I have a Signalink with a Data Cable and CAT Cable connected to the FT857 - trying to TX from Winlink / Ardop. The CAT cable successfully (automatically) switches Band and Frequency when a Channel

Another note in this in case anyone happens to see it, the additional 200-300ma draw in receive actually happens when the internal speaker output rises above some level, either due to increasing the

I recently had issues with my 857 and ATAS120. My rig is over 15 years old, as it is my ATAS. I called Yaesu Tech Support, and they recommended that I send them in. I did and the fixed and

I also suggest contacting Tim Moes at: Midwest Technical Services https://www.midwest-technical.com/ 1244 S Lake DR. Watertown, SD

Send him an email and directly ask him.? ?I don't the answer.? :( -- Rafael / NN3RP

Does he reparn the FT 897D? Richard, W9LGH

Did you get your 857 repaired.? ?I sent mine to Andy Ruggiero andyit28 at gmail dot com.? ?Same issue.? He found a 5 volt regulator bad. It was putting out 8 volts. So he replaced parts the

I use a US Navigator by Timewave.com ( https://www.timewave.com/support/Navigator/index.html ) Build my own set of cable to FT-857.? ?Works as a charm; CAT, Audio Codec, CW Winkeyer,