开云体育

Hi Hiro, JJ1FXF, Curious as to why you are lowering the max RF power on your 857 to 50 watts?? I have been a member of this group for quite a while but have not followed the discussions as I haven't

Sorry for the multiple edits in the above message. After searching for the "sdr kits panadapter" I noticed that it is the same board as the one I chose, oops! So I think you will be happy with

Noah, Have you considered the panadapter board from this website http://huprf.com/huprf/pat-board/ I installed this one in my 857d several years ago and was very happy with it. I was able to get a

Do you know it's defective? Do you have 8v dc on the input and output sides of the filter? RX8v should be on each end of the filter to enable it. Mitch N4MF

Hi all, I am looking for a reputable person to install an SDR kits Panadapter Tap Board. Looking to mount the SMA connector that the kit uses on the heatsink of the 857 (unless somebody talks me out

Did you try calling yaesu direct? I've had good luck buying parts directly from them. Leonard K. Pennock AD7AS Those who walk bravely through life, unafraid of loss or failure, find that they very

And my part is?H1102372. Tech supp 2018, page 78.

I looked at almost all the sites on the Internet that specialize in selling yaesu spare parts, but I still couldn’t find my part (

Further to the below, it is part XF1001 , a xtal Filter Yaesu part number H1102349. It’s on the parts list on page 48 of the Technical Supplement. 73….Eric VK2VE. Sent: Thursday, February

How about Yaesu spare parts? 73….Eric VK2VE. Sent: Wednesday, February 14, 2024 5:41 PM To: [email protected] Subject: [FT-857] 1st IF filter Hi all! Does anyone know where I can buy a new

Hi all! Does anyone know where I can buy a new 1st IF filter?? It is marked as "TEW T68Q". Thanks!

Thanks for the replies. Only found one commercially available cable and it’s in the UK. Im gonna use the MFJ in auto mode: it will tune with a low power carrier. I built a device that plugs into

Yes? On Sun, 14 Jan 2024 at 22:25, Dan Cameron<dcameron@...> wrote: I do want to continue my membership in the FT 857 io group. I am a ham, KD8QBF, and I own an FT 857d...the discussion s

Okay Patricia, And, I recently notice a news item that Radio Shack is on the comeback path.? Don't know where - but . . . . .? Phil

I was gonna make a joke about how Radio Shack still has 857s in stock, hihi...?But then to my shock and amazement, I saw that the brand still exists (in some strange form) and?I didn't have the

HA... I didn't catch that DUH!

Comes up as "FORBIDDEN"

Could be because the post is 22 years old dont you thinlk Mick SA4MDN

Hey Doug, Check the lock button to the right of VFO nob just below the VFO/Memory toggle button.? It has happened to all of us along with the little running man or fast tune button being triggered

Is the lock feature turned on?