开云体育

Unplug everything and then switch on. There is data going around some of those leads. This will eliminate the leads. Paul G. Chapman MInstLM G4IJL +

Remove the mic and re connect then switch on the rig and try VU2TE <unnitharakkal@...> wrote:

Just remove the mic jack and restart. Like this problem I could overcome by this method. Unni VU2TE

Contact them , maybe they have Y cable for what you need… Y-ACC Yaesu Interface Cable for FT-897, FT-857 to AT-897 radioworld.co.uk

Once upon a time the champion was the Gammaresearch HPS1A: Gamma Research HPS-1A (eham.net) <https://www.eham.net/reviews/view-product?id=5784> AFAIK this is(was?) the most compact PSU for an 100W

I recall a similar problem when a friend asked me to sell his FT857 years ago, but he kept the mic with the number pad and installed the original mic. The radio would not turn on. I plugged in my

Check and use Virtual Audio Cable (VAC) Sent: Friday, January 19, 2024 12:59 PM To: [email protected] Subject: Re: [FT-857] CAT Control and Amplifier use Simultaneously Can you have CAT control and

I use a Samlex SEC-1235M for all my 100 Watt Transceivers. This model has both meters and now costs about $175. The same power supply without the meters costs less, but I prefer to monitor the voltage

Can you have CAT control and amplifier keying at same time. Is there a Y cable available?

Have you checked the power supply voltage at the radio under load? Thanks Dan KC2STA -- Dan Ziolkowski KC2STA SKCC #4290T Ubuntu LINUX

I've had this problem for 6 months and can't find?a solution. When I turn my Radio on it cycles on/off until I turn it off and reprogram it.If I use the clone/ download I can use my rt system to

The relay clicks but the radio won’t power up. I checked the fuses and everything is okay. Anyone else have this issue?

I put a resistor in series with the MFJ-4125 and it quiet it down considerably. Note, in my opinion, if a fan needs to continuously run with no load, it’s a piss poor power supply that warms up TOO

Hi Patrica,I have had an 857D for more than a decade, and I use MFJ power supplies.?The MFJ 4225MV (yes it has? noticeable fan noise,) and the MFJ 4230MV (fan noise only at power on, then fan shuts

In my shack I have an?Astron 50A linear power supply. It is much bigger, heavier, and more expensive. It is a big iron power supply, uses a transformer instead of switching , so it makes no RF noise

Patricia,?I use the Samlex 30 Amp, SEC-1235, when not working from the shack and AC power is available. It is a small switching power supply under $200. the SEC-1223 is a 23 Amp supply for only a few

A unit NOT to buy IMHO is the MFJ 4125. It powers the radio ok, but has a Very loud fan that runs ALL the time. I was not happy with that, replaced with a Powerwerx SS300v silent and runs radio no

I have an MFJ 4230mvp, 30 amps, two sets of power pole connectors in back plus heavy duty screw lugs in front. I have used it on my 857d, my, icom 746 PROand am now using it on my Elecraft K4D every

A switching power supply rated close to 35 amps should do if you want to run full power. You will have fan noise in many cases. Try to get one designed for radio use. Others made for other

I have several 1223’s. One powers my 590s, the other powers the CS800D and IC-2730A at home. The third is in a remote shack in town that I have set up that I occasionally pack the 857D to because I