开云体育

I do that with my TS-590s at home all the time. Paul Braun WD9GCO Anchor, Amateur Radio Newsline Certified Music Junkie "Never follow anyone. Be your own hero." -- Neil Peart "Music washes from

Technique dates back to late 1950s when I updated from Heathkit to *Hallicrafters SX-99 hi HI N3AAZ *

Thanks, John -- I'll give that a try. I have a lot to learn around AGC and gain controls still. Quentin CAUDRON, PhD quentincaudron.com

Suggestion for? CW and lack of or too much AGC Especially useful for noisy band conditions Disable AGC Turn RF gain full CCW (minimum) Turn AF gain to 3/4 max Advance RF gain for your listening

Thanks, all, for the responses. Yes, this is for a FT-857D. They are hard to find ! Regarding the DSP, it performs well, but at the AF level. You can dial in the digital bandpass filter nicely, but

If my stolen FT-857D is parted out the 500Hz and 2300Hz Collins filters will be for sale. On Sat, Nov 4, 2023 at 0:20, Quentin, K7DRQ<quentincaudron@...> wrote: Hello all, Does anyone have

Quentin, et al, You did not mention for what xcvr 817/8 or 857 vs 857D IF for the 857D AND at todays price of these filters you will be disappointed IF for CW the 857D's onboard DSP (es associated

Hello all, Does anyone have a Collins mechanical filter they'd be willing to sell ? I'm looking for either : - 300 Hz, part number 526 8733 010, code YF-122CW (

https://www.arcticpeak.com/files/FT-897%20Technical%20Supplement.pdf

I don't think so, , usually insufficient current flows, due to the extra series resistance of a bad connection . Check ohms law. A bad connection will cause high volt drop across it, perhaps that was

If you want a good mobile antenna get the Little Tarheel ll they tune from 80 meters to 6 meters. tarheelantennas.com Best Regards Hanford R. Wright WA4LZC CCA # AC11-12590

Well first off if the radio was new and had not been messed with I would start by going back and removing the filter you installed, I assume you did not check the unit out prior to that, also while it

If you're going to all that trouble, why don't you just buy an ATAS so you can automatically tune it?? I replaced Hustlers after 50 years on my mobile and wish I had done it sooner!?Ron Jakubowski,

Hi, Last year, I bought a used FT-857D from a gentleman. It was new in box but sat in a closet for 15 years. Today I turned it on and heard the relays switch on and off a bunch and saw the frequency

Good for you Andreas? On Fri, 27 Oct 2023 at 22:44, Andreas, OE3ANC<mail@...> wrote: It seems like the 2 470 ohm resistors right after J1025 PIN 7 and PIN 8 where blown. I replaced them and

Well done Andreas, Phil / K4PO

This is a guess on my part as I've no interest in delving into the "how it works", but I'm pretty sure that the TXCO improves the stability of frequency generation circuits, I do know that for time

The issue with the Chinese TCXOs is that they are actually programmable PLL oscillators and have more distortion to the waveform than a single crystal would. This means that the RMDR or mixer noise

You can get a knock-off from Aliexpress, probably not as good as the Yaesu one but I'll bet better than the original one that came with the 857. John VE7KKQ

SRI to ask a silly question. What does the TCXO effect to? I understand it may stable the VFO QRH but so what’s good with it? // HIRO, JJ1FXF