开云体育

Hello?? One of my tekkie guys suggested you check the bias at the grids of the PA tubes ( Pull the HV rectifier)... a quick peek at the schematic shows this should be in the -75 or -80 range. ??

Hi Ashley, Thanks for the quick reply on my problem! My low voltage supply is good and my unadjusted bias is -80. I haven’t diddled with that much because I just built a bucking transformer that

Hi Steve, Thanks for the reply!! I started working this V2 with the phase 1 recommendations of the “wireless girl”. I made a lot of those mods but had to work through a lot of undocumented mods

Hi Tom, I've repaired and restored a few of these rigs, but it's been a while.? I read what you're saying, but my old mind is having trouble putting it all together without opening one of those

Hello?? Do we have any V2 experts to explain what I’m missing here? ?I just don’t see the resistance needed here doing what it needs to do dropping that voltage from 600 to 175. What WE

I’m still struggling with my V2. I have more recently replaced a HV power switch. It wasn’t without cost. When removing the front panel, I neglected to notice the line ?from the knob to the

Hello ?We are looking to purchase a Johnson VFO 122, working or not. Cosmetic condition not important. Thank You Ms Ashley Hall W7DUZ ??Thank YouKiss-ElectronicsMs Ashley Hall183 N 5th

I removed only the coils on the line cord to make room for a proper 3 wire line cord. Also added a rear panel fuse holder properly wired in the hot side and also moved the internal fuse to the rear

The biggest issue was the designs that used 21 Mc as the IF frequency. Nothing could fix that issue. IIRC, the FCC finally stepped in and the problem went away, eventually. 73, Dick,

Back in the early 1970s, we had TVI problems when operating on 15 meters.? The third harmonic fell on TV channel 3 and most transmitters of the day radiated considerable energy on channel 3.? The

I would not remove them or change them out. They will lower the value of the transmitter and also may cause other in circuit issues that the manufacturer was aware of while design phase of this

I recently purchased a Valiant transmitter that I'm refurbishing.? As you all know, the transmitter is full of 1/2" diameter coils made of enameled wire.? I've been told by a reputable source that

Yes it would be.? I'm hoping to find one somewhere in the East where I can drive for a pickup.

Yes, but you must buy the pair.? I'm interested in just one.

Chuck Hurley, K1TLI, has two for sale. Google Johnson Radio Restorations. Rick K8EZB

I have two Invaders not 200s just Invaders as the only designations were the Invader and the Invader 2000. complete not tested. Shipping would be EXPENSIVE from SD

Floyd, I'm curious about whether the scammer was one of our members? Have you advertised anywhere else? Can you email me privately with the scammer's message with its email address and I'll check it

A scammer response already - within 15 minutes!? If you send me an email, please include your call sign.? If you don't have an email address on QRZ.com, I'll not respond. 73, Floyd - K8AC

Anyone have an Invader 200 they'd part with? 73, Floyd - K8AC

I'm interested. I'll contact you off-list. Donald KX8K <Ashley40@...> wrote: